USER MANUAL 1. Thank You for Purchasing Monimoto! 2. Before You Start 3. How Monimoto Works 1. Ready Mode 2. Alarm Mode 3. Exit Alarm Mode 4. Periodic Check 5. Getting Started 6. Where to Install Monimoto 7. Testing Monimoto 8. Battery Replacement 9. Restoring Default Parameters 10. LED indications 11. Updating Firmware 12. Technical Specifications 13.
1. THANK YOU FOR PURCHASING MONIMOTO! Thank You for purchasing Monimoto! We will do our best to help you secure your property. If you have any issues with Monimoto, please refer to support.monimoto.
Also included: ● 2x CR123A batteries ● 1x CR2450 battery ● Micro-sized international SIM card 2. BEFORE YOU START The device can be used with iOS 9.3 or Android 5.0 devices and all subsequent operating systems. However, your smartphone must also have Bluetooth 4.0+ (BLE) functionality, as the connection between your phone and Monimoto device utilises this technology. This is the Monimoto device packed with GSM, GPS, Bluetooth and other smart tech inside.
This is a linked KEY, which is kept with the owner and works on a proximity basis. It should be kept with the owner (not anywhere inside or on the motorcycle) all the time. Monimoto KEY is not supposed to be used as a keychain and should be kept separate from your motorcycle keys – in your pocket or backpack. This will prevent you from loosing the linked KEY in case your motorcycle keys are stolen. Each Monimoto device can connect up to 3 KEYs. P.S.
Useful tips: ● The maximum Bluetooth signal range between your smartphone and Monimoto unit is 100m (~300ft) in open area. ● You can add up to 3 KEYs to your Monimoto using the app at any time later within 10m (~30ft) range. ● If you have more than one vehicle you can use the same KEY for all of them. ● Monimoto is designed to search for satellites and deliver the precise GPS location but GPS signal is usually poor inside the buildings or some other specific areas.
IMPORTANT: The app uses internet connection as its primary way to communicate with the device so it’s highly recommended to keep mobile data or Wi-Fi turned ON on your Phone at all times. Please also note that Monimoto is not a ‘real time’ device. It does not have a permanent connection with the GSM network. Only when the Alarm mode is triggered Monimoto will connect to GSM network. This method considerably saves Monimoto energy. 3.1.
3.2. ALARM MODE When Monimoto senses any type of motion, movement or vibration it will check if KEY is around. If KEY is not found, the device will enter Alarm mode. When in alarm mode Monimoto first calls the owner’s number. It will call twice and after that it will push notification to Monimoto app when precise location data is received from GPS or approximate location from GSM using CellLocate.
If you answer the first time Monimoto calls it will not call second time and this will result in quicker delivery of the Monimoto location data to the app. (Don’t worry, you won’t need to speak to your device and make people think you’re mad. Just hit the “answer” button and the call will end. This way Monimoto will know that you have been notified.) By default you will get updates every 5-10 minutes in alarm mode while the movement lasts.
BACKUP SMS In case of poor signal or network data transmission problems in Alarm mode Monimoto sends SMS with map link to the owner when the device has stopped moving and stays in steady position for more than 5 minutes. IMPORTANT: This device is optimized to work with mobile data sending push notifications in case of alarm. Backup SMS is only as supplementary channel and has monthly limits as per Terms & Service.
3.3. EXIT ALARM MODE These are the 4 main conditions for returning Monimoto back to the Ready mode: ● Exit Alarm with KEY. Once the KEY is detected within the 10m (~30ft) range, Monimoto will automatically return to Ready mode. ● Send to sleep by app. Sleep mode can be entered from Alarm mode only when the user manually chooses to sleep the device. User can put Monimoto to sleep remotely for 1, 5 or 24 hours using the app.
● Deactivate by app. You can turn off the Alarm mode by app only when your phone is within the range of Bluetooth signal. If you open the app and establish Bluetooth connection with Monimoto on settings Tab– it goes to Ready mode and the Alarm mode ends. ● If there is no motion for 30 minutes Monimoto cancels alarm 4. PERIODIC CHECK Monimoto regularly performs a battery check and updates status to your phone.
5. GETTING STARTED STEP 1 Search “monimoto” in App Store or Google Play Store or click the button: Download the Monimoto app and install it on your smartphone. STEP 2 Run the Monimoto app and follow the on-screen step-by-step instructions that will guide through the setup process. IMPORTANT: Once setup process has been completed you should receive SMS from your device. Be sure to add that number to your contacts with the appropriate name so you recognize it immediately in case of alarm.
STEP 3 After pairing hide and fix Monimoto using two zip ties in your vehicle. 6. WHERE TO INSTALL MONIMOTO Monimoto is intended to be placed inside your vehicle in order to track it down in case of a theft. After setting up and configuring your device hide it in your motorcycle or other vehicle.
7. TESTING MONIMOTO 1. Leave your KEY at home. 2. Switch off Bluetooth on your phone. 3. Take your Monimoto-equipped vehicle for a test drive. Or simply do something to keep your bike moving it for at least 8 seconds. 4. In approx. 1 minute you will receive a call from Monimoto device and soon after the call pushnotification should arrive to the Monimoto app. 5. Open the app and check whether it is showing the precise GPS or approximate GSM location. 6.
KEY v1 1. Open the KEY lid using 2 euro cent coin. 2. Remove the old battery from the battery pocket. 3. Position the new CR2032 battery and insert it into the battery pocket facing positive (+) terminal up. 4. Close the lid following small pointers with the same 2 euro cent coin. KEY v2 1. Insert flat screwdriver into special hole and lift. 2. Two black plastic pieces should be separated. Position the new CR2032 battery and insert it into the battery pocket facing positive (+) terminal up. 3.
Battery life could be affected by the selection of the "Periodic Check". For example, if you want to see the Monimoto location any time during the day by enabling the location 9. RESTORING DEFAULT PARAMETERS 1. Ensure the batteries are inserted into your Monimoto. 2. Push and hold the reset button for 3 seconds button 3. You will see a few LED blinks and as a result you will see one long green LED 3 seconds blink. 10.
/unable to register to 2G/3G network Weak continuous light 1. Boot mode in progress 2. Firmware was deleted and new one was not successfully uploaded Either OFF or one long Battery low flash every 1 second 11. UPDATING FIRMWARE If new firmware is available, you will see it once you connect in to Monimoto with the app by pressing Connect from the settings menu. 12.
MM6 model GSM modem frequency 800/850/900/1800/1900/2100MHz Bluetooth version and v4.1; 2.4GHz frequency A-GPS lock time (satellite Hot start: <2 sec(open sky); Cold start: <45 sec Dust and water resistance Monimoto: IP65 rating Monimoto KEY: IP65 Range of operating -15… +55°C (-4… 131°F) temperatures Dimensions 126x35mm (4.96×1.38in) *The operation time might vary in different conditions. 13.
terms and conditions for download, installation, display and use of the mobile application (“Application”) before you download, install, display or use the Application. TECHNICAL SUPPORT In order to ensure continuous and proper operation of the MONIMOTO device and uninterrupted service, it is the responsibility of the User to make sure that: (i) the product is properly installed, and (ii) there is constant internet or GSM connection and electrical supply (low battery must be replaced in time).
● Keep new or used CR2450 batteries (ones that are used in Monimoto KEY3 or CR2032 for older KEY models) out of the reach of children. If a battery is swallowed, it can lead to serious burns resulting in internal bleeding or death. ● Risk of explosion if battery is replaced by an incorrect type. ATTENTION! Monimoto will use mobile data if it is enabled on your SIM card. This is to improve accuracy and speed of location tracking and SMS text message services.
following all guidelines outlined in this manual and in accordance with the operating conditions specified. The warranty is void if the system has been disassembled or exposed to mechanical impact, chemicals, high humidity, fluids, corrosive and hazardous environments or force majeure factors.
CONSUMER PROTECTION LAWS FOR CONSUMERS WHO ARE COVERED BY CONSUMER PROTECTION LAWS OR REGULATIONS IN THEIR COUNTRY OF PURCHASE OR, IF DIFFERENT, THEIR COUNTRY OF RESIDENCE, THE BENEFITS CONFERRED BY THIS WARRANTY ARE IN ADDITION TO ALL RIGHTS AND REMEDIES CONVEYED BY SUCH CONSUMER PROTECTION LAWS AND REGULATIONS. This warranty grants upon you specific legal rights, and you may also have other rights that vary by country, state or province.
It is strictly forbidden to copy and distribute the information contained in this document or to pass thereof to a third party without an a priori written authorization obtained from “Monimoto UAB” “Monimoto UAB” reserves the right to update or modify this document and/or related products without an a priori warning. “Monimoto UAB” hereby declares that smart alarm for motorcycles MONIMOTO is in compliance with the essential requirements and other relevant provisions of the RED Directive 2014/53/EU .
FCC compliance information THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
SAFETY MANUAL
EN For full User Guide visit: monimoto.com TERMS OF USE The following terms and conditions govern the use of the MONIMOTO device and contains important information on limitations regarding the product’s use and function, as well as information on the limitations of the manufacturer’s liability. Please carefully read these terms and conditions for download, installation, display and use of the mobile application (“Application”) before you download, install, display or use the Application.
FCC related Radiofrequency radiation exposure information: this equipment complies with radiation exposure limits prescribed for an uncontrolled environment for fixed and mobile use conditions. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and the body of the user or nearby persons. Drive with the key fob or remove batteries from the device if the device is installed under the saddle less than 20 cm from the human body.