C-120 Mojo Access Point Quick Start Guide Package Contents You should have received the following components in your C-120 package.
Mounting the C-120 1. Affix bracket to T - Grid 3. Place first screw on device on the lower notch on bracket 2. Rotate bracket to snap on toT- Grid 4. Rotate device on the bracket 5.
Getting the C-120 Online Step 1: Power up If using PoE, plug one end of the Ethernet cable into the PoE switch or injector and plug the other end into the Ethernet + PoE port (LAN1) on the C-120. Make sure the PoE source you are using is turned ON. OR As an alternative to PoE, insert the power adapter plug into an AC power outlet and the other end into the power input port on the C-120. Warning: If not using PoE, make sure you use only an AC power adapter supported by the C-120 access point (AP).
Troubleshooting After the C-120 is powered ON and connected to Ethernet, if the status of LED 1 (Power) remains Solid Orange, it indicates that the AP is not able to function normally. The following guidelines may help you to quickly diagnose and fix the problem. LED Status What does it mean? Power Ethernet (LAN1) Wi-Fi (2.
FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
IC Statement: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
