1 2 IN THE BOX 3 6 1. M asterTracker Cartridge with Stylus Guard 2. Stylus Cleaning Brush 4 3. Hex Driver 7 4. 2.5mm x 8mm Hex Screw (2) 5. 2.5mm x 10mm Hex Screw (2) 6. 2.5mm Metal Washer (2) 7. 2.
1 White Red Green Black SETUP Keep stylus guard in place during installation to prevent damage to the needle 1. C onnect the four headshell leads, making sure the color-coated leads match the corresponding colorcoded pins. Hex Screws 2 Washers 2. C arefully mount cartridge to the headshell. Using the threaded screw holes in the metal body as guides, gently tighten the screws while leaving enough tolerance to make slight adjustments.
3. C arefully remove stylus guard, balanced the arm, and set an approximate tracking force of 2g. 4. U sing the Mobile Fidelity GEO-Disc or other alignment tool, set overhang/zenith by adjusting cartridge so the stylus tip sits right on the bullseye while the cantilever is parallel with the line that intersects the bullseye. Then tighten the cartridge screws and double-check your work. 3 Center Line 4 I f your turntable allows, check VTA, azimuth, and anti-skate. Double-check overhang/ zenith.
USAGE AND CARE Always use tonearm’s lift mechanism for cueing Back to Front Clean your records before each play to avoid unnecessary wear After each play, gently clean your stylus, always brushing back-to-front. We recommended Mobile Fidelity LP#9 Stylus Cleaner.
Type StudioTracker UltraTracker MasterTracker Dual Magnet (MM) Stereo Dual Magnet (MM) Stereo Dual Magnet (MM) Stereo Weight 6.4g 9.7g 9.7g Tracking Force 1.8 – 2.2g 1.8 – 2.2g 1.8 – 2.2g Impedance 47kOhm 47kOhm 47kOhm Capacitance 100pF 100pF 100pF Frequency Response 20-20,000Hz 20-25,000Hz 20-25,000Hz Stylus Elliptical Nude Elliptical Micro-Line Output Voltage 3.5mV 3.
www.mofielectronics.