Dimensions Guide

Voss™ Technical Specication
Grab Bar YG5112, YG5118, YG5124
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
YG5112CH – 12" Grab Bar
Chrome Finish
YG5118CH – 18" Grab Bar
Chrome Finish
YG5124CH – 24" Grab Bar
Chrome Finish
YG5112BN – 12" Grab Bar
Brushed Nickel Finish
YG5118BN – 18" Grab Bar
Brushed Nickel Finish
YG5124BN – 24" Grab Bar
Brushed Nickel Finish
YG5112ORB – 12" Grab Bar
Oil Rubbed Bronze
YG5118ORB – 18" Grab Bar
Oil Rubbed Bronze
YG5124ORB – 24" Grab Bar
Oil Rubbed Bronze
YG5112BG – 12" Grab Bar
Brushed Gold
YG5118BG – 18" Grab Bar
Brushed Gold
YG5124BG – 24" Grab Bar
Brushed Gold
1. Please note that screws MUST be mounted into a wood stud for secure installation.
2. Decide whether you would like to position your grab bar horizontally, vertically or at an
angle, remembering that BOTH ends of the grab bar MUST be positioned over a wood
stud (unless using secure mount anchors).
3. Foreasierinstallationandmountingremove3setscrewsfromeachangeand
remove bar from SecureMount™ Flange.
4. Removecoverandre-assembleangetobarbytightening3setscrews.
5. Placegrabbarandmarkthreemountinglocationsoneachofthetwograbbaranges
with a pencil.
6. Drill 1/8" diameter pilot holes at each screw location. Make sure to drill into the stud.
7. Install3screwsandwasherseachSecureMount™angeandtightenuntilsecure.If
desired, apply silicone caulk to the back of the SecureMount™ plate to guard against
water penetration.
8. Afterscrewsareinstalledeachside,dis-assemblebarfromSecureMount™angeby
removing set screws.
9. Re-install covers.
10. PlacebaroverSecureMount™angesandtightenallsetscrews.
11. Snap on covers.
Topreservethenenishofthisproduct,cleanonlywithasoftdampcloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Grab Bar posts and bars are constructed
of stainless steel.
Compliance:
• ADA, ANSI, ASTM, CSA
• Tested to 500lbs. pull
Stock Number: _______________________ Grab Bar
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Voss is a trademark of
Moen Incorporated. All rights reserved.
3-1/8"
(79mm)
A
B
2-5/8"
(67mm)
1-1/2"
(38mm)
1-1/4"
(32mm)
Dim. A Dim. B
YG5112 12" 15.125"
YG5118 18" 21.125"
YG5124 24" 27.125"