Use and Care Guide

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006 Literature #BA1347
Towel Ring
is constructed of zinc.
q
YB
2
8
86BN
–
Towel Ring
Brushed Nickel Finish
q YB2886CH – Towel Ring
Chrome Finish
q YB2886ORB – Towel Ring
Oil Rubbed Bronze Finish
Cleaning Instructions:
This product features the Pro+Fit Installation Mounting System. If you do not have the
Pro+Fit Installation Template please use the following instructions. (Note: only one hole
is required per mounting post.)
1. Mark on the wall where you want to install the product.
2. Using ¼” drill bit, drill one pilot hole for the post.
3. Position mounting post to wall by inserting wall anchor into pilot hole and pressing
firmly.
4. Make sure that locking tab on mounting post is facing down (6 o’clock).
5.
Tighten wall anchor screw while holding mounting post firmly in place. DO NOT over
tighten (6 – 8 full turns will secure the anchor).
6. Attach post by pressing firmly to mounting post unt
il it clicks. (The square opening at
the base of the post must be facing down to match-up with locking tab.)
If you are mounting any parts into a hard surface snap off the anti-rotation fins on the
back of the mounting post.
Stock Number:
______________________Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Ring
YB2886
Eva™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.