Technical Specifications
Towel Bars
are stamped from
Type
304 stainless steel.
q
P1718SS
–
18” Towel Bar
Stainless Steel Finish
¾” Square Bar
Concealed Screw Mounting
q 23418SS – 18” Bar Only
Stainless Steel Finish
¾” Square Bar
q P1724SS – 24” Towel Bar
Stainless Steel Finish
¾” Square Bar
Concealed Screw Mounting
q 23424SS – 24” Bar Only
Stainless Steel Finish
¾” Square Bar
q P1730SS – 30” Towel Bar
Stainless Steel Finish
¾” Square Bar
Concealed Screw Mounting
q 23430SS – 30” Bar Only
Stainless Steel Finish
¾” Square Bar
q P1736SS – 36” Towel Bar
Stainless Steel Finish
¾” Square Bar
Concealed Screw Mounting
q 23436SS – 36” Bar Only
Stainless Steel Finish
¾” Square Bar
q P1700SS – Towel Bar Posts (Pair)
Stainless Steel Finish
Fit ¾” Square Bar
Concealed Screw Mounting
Cleaning Instructions:
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 (800) 321-8809 •
FAX: (800) 848-6636 • INTERNATIONAL: (440) 962-2000 •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882
-
0116
1. Remove mounting brackets from back of fixtures by loosening the set
screws.
2. Position assembled unit on wall in desired location.
3. Lightly mark the outlines of the bases of the unit.
4. Center mounting brackets inside the outlines.
5. Mark hole locations. Attach brackets to wall using 1 3/8” screws
(provided).
6. Mount bases on brackets. Tighten set screws on the bottom.
Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not available, the following optional fasteners are
suggested: Tile/Masonry – Plastic or Lead Anchors; Plaster/Drywall –
Toggle Bolts.
Stock Number:
______________________Towel Bar
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Bars
P1718, P1724, P1730, P1736
Stainless Steel Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Copyright CSI Bath Furnishing Division of Moen 02/22/01