Specification

Halle
™
Technical Specication
Robe Hook MY0303
Stock Numbers: Dimensions:
Cleaning Instructions:
MY0303BN – Robe Hook
Brushed Nickel Finish
Installation Instructions:
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Robe Hook is constructed of zinc.
Stock Number: _____________________ Robe Hook
By Moen Incorporated
4-1/8"
(106mm)
2"
(51mm)
2-3/4"
(69mm)
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321 -8809 • FAX: [phone]
INTERNATIONAL: (440) 962 -2000 • FAX: [phone]
CUSTOMER SERVICE (USA) : 800 -882-0116 • FAX: [phone]
WWW.MOEN.COM
1) Position the mounting template on the wall in the desired location.
2) Using a level, align the template and tape it to the wall.
3) Drill two ¼” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).
4) Remove the template from the wall.
5) Lightly tap anchors until ush with the wall.
6) Remove mounting posts from the product assemblies by loosening
each setscrew.
7) One at a time, place each mounting post over anchors (notch facing
downward) and insert screws through post into anchors.
8) Tighten screws.
© 2019 Moen Incorporated. Moen is a registered trademark and Halle™
is a trademark of Moen Incorporated. All rights reserved.