Dimensions Guide

Adjustable Tub/Shower Seat is made
from high impact polypropylene. Legs
are polished anodized aluminum. Feet
are gray rubber.
WARNING
TO PREVENT SERIOUS OR FATAL INJURY:
Insure product is assembled, adjusted and used
properly. FOR USE ONLY BY PERSONS
WEIGHING LESS THAN 250 POUNDS. Failure
to follow correct assembly and/or adjustment
procedures can make the seat unstable. ALL
FOUR LEGS MUST BE LOCKED IN PLACE AT
THE SAME HEIGHT. DO NOT jump on, stand on
or tilt. Contact CSI immediately at 1-800-882-
0116 if any components are missing or damaged.
Do not modify or substitute any components.
FOR QUESTIONS OR ASSISTANCE WITH
ASSEMBLY CONTACT CSI AT 1-800-882-0116.
Consult healthcare professional for advice and
instructions specific to user’s needs before use.
 DN7025 – Adjustable Tub/Shower
Seat
White w/ Polished Aluminum
Adjustable 14.0” to 21.0”
Photo Box Packaging with Handle
25 3 00 AL M OEN DRIVE  NORT H OL M ST ED, OH 4 4 07 0 (80 0) 321 -8809 
FAX: [phone]  INT ERNAT IONAL: (4 4 0) 9 6 2 -2000 
FAX: [phone] CUST OM E R SERVICE (USA): 80 0 -882-0116
WWW.M OEN.COM
©Co p yri g h t Cre ati ve Speci a l ti e s Internati o nal Li terature #B A 1 68 1
1. Position legs. Place leg “1” into grove “1” of the plastic seat
panel so that the number “1” marks are next to each other.
Then place leg “2” into groove “2”, over leg “1” so that the
number “2” marks are next to each other.
2. Attach legs. Insert a 1 ½” screw through a washer and the
center hole of the legs and seat. Tighten several turns. Insert
remaining four screws through washers into the four leg holes.
Tighten all five screws fully. Test seat. Retighten as needed.
3. Adjust leg height. Push in button on leg, slide leg to desired
height and allow button to pop out and lock leg in place.
Repeat for each leg, making sure all four are adjusted to the
same height.
Stock Number:__________Adjustable Tub/Shower Seat
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Adjustable Tub/Shower Seat
DN7025
Home Care Technical Specification