Installation Guide

MB004B

SERVICE KIT INSTRUCTIONS

INSTRUCTIONS POUR LE SERVICE

PN1248

HI FLOW CARTRIDGE -

TWO HANDLE FAUCET

CARTOUCHE A DEBIT ELEVE -

ROBINET A DEUX POIGNEES

TO DISASSEMBLE THE FAUCET:

Turn OFF BOTH water supplies.

These instruc tions apply to both

the hot and cold sides. Parts and

procedures are the same for each side.

1. Use a knife blade.

Pry o the handle cover.

2. Use a screwdriver and

remove the handle screw.

3. Pull handle knob up and o.

4. Unscrew the cartridge nut. Use a wrench.

5. Using pliers, pull cartridge straight up, by

the cartridge stem.

POUR DEMONTER LE ROBINET:

Fermez les alimentations d'eau chaude et

d'eau froide. Ces instructions s'appliquent

à la fois aux côtes chaud et froid. Les pièces

et les procèdures sont les mêmes pour

chacun des côtes.

1. Avec la lame d'un couteau

ôtez le couve cle de la poignée

2. Otez la vis de la poignée

avec un tournevis.

3. Otez le bouton de la

poignée en tirant vers vous.

4. Dévisser l'écrou de la cartouche

en utisant de clé.

5. retirez la cartouche en prenant la

tige de la cartouche entre

des pinces et tirez vers le haut.

(over)

(suite)

PAGE 1
MB004B SERVICE KIT INSTRUCTIONS INSTRUCTIONS POUR LE SERVICE PN1248 HI FLOW CARTRIDGE TWO HANDLE FAUCET CARTOUCHE A DEBIT ELEVE ROBINET A DEUX POIGNEES TO DISASSEMBLE THE FAUCET: Turn OFF BOTH water supplies. These instruc tions apply to both the hot and cold sides. Parts and procedures are the same for each side. 1. Use a knife blade. Pry off the handle cover. 2. Use a screwdriver and remove the handle screw. 3. Pull handle knob up and off. 4. Unscrew the cartridge nut. Use a wrench. 5.
PAGE 2
To Assemble: 1. 2. 3. 4. 5. Failure to follow these instructions might cause the cartridge to be damaged beyond repair. Turn cartridge stem LEFT (counterclockwise) - to on. Push the cartridge straight down into the body. Fit the key on the cartridge into the notch in the body. This will position the handle stop on the cartridge to the side, AS SHOWN. Screw down the cartridge nut. Start by handle and DO NOT CROSS THREAD. Tighten firmly with a wrench.