Installation Guide

Solid Surface Product Using Manual
Caution
• Carefully read the instructions before starting the installation.
• This bathtub should be installed by an experienced plumber.
• You will need at least two people to install this product properly.
• In order to reduce the risks of personal injuries, do not support or lift the bathtub by the rim. Provide
adequate support under the feet.
• Manufacture is not responsible for any damage to the unit or personal property caused by improper
installation. If you disregard instructional warnings, you will void your warranty.
• Unpack and inspect the bathtub for damage. Return the bathtub to the carton until you are ready to
install.
• Install the bathtub on an adequately supported, level floor.
• Before installation, ensure proper access to the final plumbing connection.
• Adhere to all local plumbing codes
Installation Manual
1. Remove the bathtub from its carton and place it on a protective floor covering material to
prevent damage to the bathtub or floor.
2. Position the tub in its final location and trace its outline with a pencil.
3. Position a clean drop cloth or similar material in the bottom of the bathtub. Be careful not to
scratch the surface of the bathtub.
4. Level the bath by turning the leveling feet at the bottom of the tub.
5. If the drain waste pipe is not directly below the drain please use an adjustable flex pipe
(included) and follow steps 6-10.
Using Flex Pipe (Included)
6. Place tub on its side and connect flex pipe to the Tub drain pipe using the lock nut connector.
7. Arrange the flex pipe and connect its end to the drain waste pipe.(use PVC cement to connect)
8. Flip over the bathtub.
9. Fill the bathtub to the overflow and check for leaks.
10. Affix the bathtub by applying silicone on the contour of the base. Let dry 24h.
1