Halo Installation Step 1 Brackets facing out Remove glass face by lifting face up off the firebox with 2 people. Set glass face against the wall with brackets facing you.
Halo Installation Step 2 Adhesive Film RGB lights Module Adaptor Wire Remote Locate Halo light kit. Contents are (1) RGB light wheel (1) module (1) Adaptor Wire (1) Remote.
Halo Installation Step 3 With adhesive side down, center RGB lights on āLā metal of the glass and wrap around Remove adhesive cover from back of module and press against left side of the glass low enough so you can connect the RGB lights to and hang IR sensor just below the glass.
Halo Installation Step 4 AC Outlet Re-attach glass face and plug adaptor wire into the AC outlet on the right side of the firebox
Halo Installation Step 5 It is best to hang IR sensor just below the glass face for best functionality