Bluetooth Portable CD Radio MET36E MPC5050 MPC 5050 MPC-5050 Operation Guide PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATION 1
Warnings and Precautions WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Location of the Controls L 3
Location of the Controls 1. AUX IN Jack ( LINE IN ) 2. POWER Button 3. / TUNE+ or / TUNE - Button 4. PLAY / PAUSE / PAIR Button 5. STOP / M+ (Memory Up) Button 6. X-BASS Button 7. FM Rod Antenna 8. CARRY HANDLE 9. REPEAT Button 10. MEM / PROG Button 11. SOURCE Button 12. VOLUME Buttons 13. CD OPEN Button 14. CASSETTE PAUSE Button 15. CASSETTE STOP/EJECT Button 16. CASSETTE F.FWD or REW Button 17. CASSETTE PLAY Button 18. CASSETTE REC Button 19. SPEAKERS 20. LCD Display 21. PHONES Jack 22.
Getting Started / Main Operation Power On the Unit Press the POWER button to turn on or off unit. Adjusting the Volume Press the VOLUME buttons to increase or decrease the volume sound level. Adjusting the Rod Antenna The aerial should be extended to ensure good reception in FM radio modes. It may be necessary to alter the position of the UNIT and/or aerial to achieve the best signal. Using Headphones You will require headphones fitted with a 3.5mm diameter stereo plug and an impedance of 8-32 ohms.
recemanually Listening the Radio Using the Radio 1. 2. 3. 4. After power connect, press the POWER button to turn on your unit. If necessary, press the SOURCE button to select FM mode. The LCD DISPLAY will show the frequency of radio. Press or hold the / TUNE+ or / TUNE – button to scan correct radio frequency. Automatic Tuning of Radio 1. In FM mode, hold / TUNE+ or / TUNE– button to automatically search for the next available station. 2.
Listening CDs Disc Insert a CDs disc. 1. 2. 3. Open the CD door by pressing CD OPEN button. Insert a disc into the disc compartment with the title side upwards. Close the CD compartment door, “- - -” is displayed for few seconds, and the total number of title will show on display and disc will auto start play. Remove a CDs disc. Press the STOP / M+ button once, open the CD door by pressing CD OPEN button. Remove the CDs disc when it has stopped spinning. Playing a CDs Disc 1. 2. 3. 4. 5. 6. 7. 8. 9.
Listening Bluetooth Device This unit can connected to mobile phones using a procedure by following a few simple steps, a mobile phone can be paired with the unit in a matter of seconds. Setup Your Unit on Bluetooth ( BT) Mode 1. After power connect, press the POWER button to turn on your unit. 2. If necessary, press the SOURCE button to select (BT) mode , 3. At the time, the “bt” digits flash on LCD display. 4. Finish this simply setting and go to next step below.
Listening Bluetooth Device-Continuous Playing Audio Via Bluetooth 1. When successful BT (Bluetooth) pairing, Press the PLAY / PAUSE / PAIR button to play or pause audio files from your Bluetooth device. 2. Press / TUNE+ or / TUNE– button to jump to next / previous music track of your Bluetooth device. 3. If press the PLAY / PAUSE / PAIR button cannot play or no music listening. You must go to your mobile phone “Music Centre or Media Player” to manual search music.
Listening Cassette Music Inserting or remove a Cassette Tape 1. To insert your cassette tape: Press the button to open the cassette door. Insert your cassette tape into the compartment with exposed section of the tape facing downwards. The side that your wish to listen to or record onto should be facing towards you. Push the cassette door until it locks in place. 2. To remove your cassette tape: press the button to open the door then lift the cassette out. Playing the Cassette Music 1. 2. 3. 4. 5. 6.