User Manual Part 2

MX-PROX-BOX
32.795-001_US_11/2016
Regulatory Notice
MX-Proximity-Box
Standard Delivery
MX-Proximity-Box
Federal Communications Commission (FCC) and Industry Canada (IC)
Notice for MX-PROX-BOX
(M/N: MX-Proximity-Box)
(FCC ID: YYRPROXCE, IC ID: 9357A-PROX)
NOTICE:
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de licence.
L‘exploitation est autorisée aux deux conditions suivantes:
(1)
l‘appareil ne doit pas produire de brouillage, et
(2) l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d‘en
compromettre le fonctionnement.
NOTICE:
Changes or modications made to this equipment not expressly approved by MOBOTIX AG may void the FCC
authorization to operate this equipment.
NOTICE:
This Class B digital apparatus complies with Canadian ICES-003.
NOTICE:
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Ministry of Internal Aairs and Communications Notice for MX-PROX-BOX
NOTICE:
• This device has been granted a designation number by Ministry of Internal Aairs and Communications.
• This device should not be modied (otherwise the granted designation number will be invalid).
Dimensions
75 mm/2.95 in
MX-Proximity-Box
Motion Detection with
Radar Sensor Technology
Radar-based detection for any
camera with MxBus connector
More information:
www.mobotix.com > Products > Accessories > Interface Boxes
• MX-Proximity-Box
• 1 screwdriver
• 1 plug 3 to 5 mm
• 1 plug 5 to 7 mm
• 1 MxBus cable 0.5 m/1.64 
• 2 washers 4.3 mm dia.
• 2 stainless steel wood screws 4x40 mm
• 2 screw anchors S6