User Manual Part 1

MX-PROX-BOX
32.765-001_EN_10/2016
Quick Install
MX-Proximity-Box
Standard Delivery
MX-Proximity-Box
Motion Detection with Radar
Sensor Technology
Radar-based detection for any
camera with MxBus connector
More information:
www.mobotix.com > Products > Accessories > Interface Boxes
• MX-Proximity-Box
• 1 screwdriver
• 1 plug 3 to 5 mm
• 1 plug 5 to 7 mm
• 1 MxBus cable 0.5 m/1.64 
• 2 washers 4.3 mm dia.
• 2 stainless steel wood screws 4x40 mm
• 2 screw anchors S6
Installation Instructions
1. Find a good location for installing
Select the location for installing the device so that the
objects you want to detect are within the detection area
of the box (80° horizontally, 34° vertically). Note that
the detection precision is best if the objects are moving
perpendicular to the front label of the MX-Proximity-Box:
80° horizontally
34° vertically
2. Attach the box
Attach the MX-Proximity-Box at the mounting position
with the cable ports pointing downwards. Next, remove
the box cover (three screws).
3. Prepare the connection cables
Before proceeding, make sure there is no current on
the MxBus wires!
Cut the MxBus wires to size (2-wire, 0.6–0.8 mm diame-
ter). When using wires without sheath, strip the insulation
of the wires for 5 mm and push the wires through the
eight-wire plug (le).
When using a cable with jacket (e.g., J-Y(St)Y), remove
the pre-installed eight-wire plug and insert the appro-
priate cable plug (3 to 5 mm or 5 to 7 mm). Press the
rubber plug into the casing in such a way that the
rims stick out equally on both sides. Push the cable
through the plug, remove the sheath on a length of
15 mm/0.6 in and strip the insulation of the wires for
about 5 mm/0.2 in.
4. Connect the MxBus wires to the terminal
Connect the MxBus wires to the terminals of the
MX-Proximity-Box using the screwdriver. Make sure
to maintain the polarity (see sticker on the front of
the terminal).
5. Mount the cover
Mount the cover back onto the MX-Proximity-Box and
aix it using the cover screws.
6. Connect the MxBus wires to the opposite side
Connect the MxBus wires as described in the corre-
sponding manual to the MOBOTIX camera or to another
MxBus module connected to a camera (e.g. KeypadRFID,
MX-DoorMaster). Make sure not to exceed the overall
length of the MxBus wiring (max. 100 m/328 ).
MxBus plug
in MOBOTIX
camera
Connection Example
MOBOTIX Camera
2-wire MxBus wiring to camera
(max. 100 m/328 )
MOBOTIX IP Video Door Station
MX-T25M-Sec-D11
MOBOTIX MX-Proximity-Box
MX-PROX-BOX
LEDLED
Radar sensor
LED Signaling
LED Meaning
Operating
status
(le)
Not connected
Regular operation
Unencrypted communication
Error during communication
Radar signal
(right)
Leaving
Approaching
Movement
The intensity of the LEDs varies depending on the strength of
the reected radar waves.
Operating Status Radar Signal
LED o
LED permanently on
LED blinking