User's Manual

QR Controller User Manual !

Revision 1!

April 1, 2021"

Notes"

QR Controller is an electronics module that allows for user interaction with a pedal and

electric bicycle, and communicates the bike state and location to the server using a

cellular connection. "

Instructions"

QR Controller has following user interface: !

The two large circles are capacitive touch buttons intended for users to interact with the

device. The left button puts a ride on hold, the right button reports issues with the bike,

and all buttons wake up the module. The three small LEDs in the middle are use for status

indication of the bicycle. The area in the middle is where the RFID antenna is located, and

allows to start rental using RFID card. "

PAGE 1
QR Controller User Manual Revision 1 April 1, 2021 Notes QR Controller is an electronics module that allows for user interaction with a pedal and electric bicycle, and communicates the bike state and location to the server using a cellular connection. Instructions QR Controller has following user interface: The two large circles are capacitive touch buttons intended for users to interact with the device.
PAGE 2
Accessory List No accessories are to be used with this device. Accessory Specification No accessories are to be used with this device. Declarations Users are strictly forbidden to change the equipment. The socket-outlet shall be installed near the equipment and shall be easily accessible. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
PAGE 3
0 cm