WBS Gen1.
Wireless Base Station: If you need help, WBS calls for help whenever you press the EMERGENCY button. It works anywhere, anytime there is cellular service. Where to place WBS in your house ● On a hard, flat, non-metallic surface. How to use WBS (1) Power Up ● Plug WBS’s power adaptor into a electrical outlet that is NOT controlled by a wall switch. Power Switch ON WBS Gen 1.0 ● Power switch ( at the bottom case of WBS) to “ON” position.
● The EMERGENCY and RESET button will light up. ● Indicating that power has been detected by WBS. ● The voice “system ready” also prompts from WBS at the same time and it is ready to use. (2) Calling for Help ● To call for help, you don’t have to do anything except press EMERGENCY button. ● Once the button is pressed, one of MobileHelp personal response associate will answer to you. ● MobileHelp personal response associate will speak to you through your WBS’s built-in speaker.
FCC Regulations: This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.