Installation Instructions
Waterproof Wall Button
When used in conjunction with MobileHelp’s Cellular Base Station and/or Mobile Device,
the waterproof Wall Button allows you to obtain emergency help with the press of a button.
The Wall Button can be mounted on a at surface such as a wall or placed on a table top.
Mounting hardware and two-sided tape is included. The Wall Button has an LED Light that will
communicate the following:
Light Indicator What it Means
RED
When you press your emergency Wall Button, the LED light will ash red.
AMBER
When the battery level is low, the LED light will blink amber.
LED
Light
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modications not expressly approved by the part responsible for compliance could void the user’s
authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
MHP-06676B