Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC Forward Camera (FNOL), Cab Camera Front Bumper Camera (FNOL) Left Side Support Camera (FNOL) High Center Left Lightbar/Pylon Rear Camera (FNOL) Right Rear Camera (FNOL) Left Rear Camera (FNOL) Low Center-Left Rear Camera (FNOL) 16 September 21, 2021
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 17 September 21, 2021
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 9.1. Forward (FNOL) and Cab View Interior Camera Mounting This section describes the installation procedures for the interior mount cameras. Interior cameras are not suitable for outdoor operating environments. Before mounting cameras, remove all interior trim components needed to drop the headliner for camera cable routing.
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC Sample Camera Views Forward View Cab View Installation Steps 1) Choose a stable mounting location high up and centered on the windshield. Interior front facing cameras should be mounted as high as possible. Ensure that camera has unobstructed view which isn’t blocked by rearview mirrors or sun visors in the down position. 2) Remove adhesive cover and place adhesive pad on camera bracket firmly.
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 9.2. Coiled Ethernet Cable Kit – Flatbed only This section describes the installation of a flexible and extendable coiled Ethernet cable for providing Power-over-Ethernet (PoE) connections to one or more IP cameras on moving flatbeds. It is designed for installation on the outboard right or left side of the moving bed and vehicle chassis to allow for full movement of the bed.
Vehicle Monitoring and Locating System Tow Truck Installation Procedures 4) 5) 6) 7) 8) Mobile Video Computing Solutions LLC and rearward and measure that the distance between these two points never exceeds 6’ at any time. Attach the chassis end of the coiled cable (with the 5M straight Ethernet cable) to a ¼” bolt. Do not tighten yet. Attach the bed end of the coiled cable to a ¼” bolt. Do not tighten yet.
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC Coiled Cable Attached to Bed Coiled Cable Attached to Chassis Bed Fully Extended 22 Bed Fully Stowed September 21, 2021
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 9.3. Ethernet Switch Module – Flatbed with multiple cameras only This section describes the installation procedures for the Ethernet Switch Module which is required for flatbeds with more than one IP camera on the moving bed. It connects to the Coiled Ethernet Cable Kit to receive the PoE power and signals from the MDVR.
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 5) Route appropriate camera cables to their respective cameras and connect with an Ethernet Exterior connector. 6) Coil, ziptie and stow any excess cable to prevent snagging when the bed is moving.
