Users Manual Part 2

ManualsBrandsMobile Video Computing Solutions ManualsElectronicsMobile Digital Video Recorder

Vehicle Monitoring and Locating System Mobile Video Computing Solutions LLC

Tow Truck Installation Procedures

25 September 21, 2021

9.4. Left and Right (FNOL) Rear Pylon Camera Mount

This section describes the installation procedures for Left and Right Rear Camera on the lightbar

pylons. This is a required view for vehicles in the FNOL program. If the cab mount option

is chosen, it will use a wired camera connection. For flatbeds with moving lightbars and pylons,

a wireless transmitter must also be mounted along with the lightbar/pylon camera and power

tapped from flatbed rolloff lighting power.

Mounting Examples

Right Pylon

Left Pylon

Sample Camera Views

Summary of content (6 pages)

PAGE 1
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 9.4. Left and Right (FNOL) Rear Pylon Camera Mount This section describes the installation procedures for Left and Right Rear Camera on the lightbar pylons. This is a required view for vehicles in the FNOL program. If the cab mount option is chosen, it will use a wired camera connection.
PAGE 2
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC Right Pylon Left Pylon Installation Steps 1) Choose a stable mounting location high up and outboard on driver and passenger side pylons. Cameras should be mounted as high as possible for good viewpoints. 2) Position the camera in the chosen location and mark holes for mounting screws and for camera cable pass-through into vehicle.
PAGE 3
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 9.5. Winch Rear Camera Mount (FNOL) - Flatbed This section describes the installation procedures for Winch Rear Camera to the winch bracket of a flatbed. This is a required view for vehicles in the FNOL program. A rugged bracket must be installed to the winch bracket for protection of the winch camera.
PAGE 4
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC Installation Steps 1) Hold the doghouse next to the winch bracket and look for any available bolts which can be loosened and used to secure the doghouse. If none are found, determine if drilled holes or some tack welds could be used to secure the doghouse to the top of the winch bracket. Secure the doghouse.
PAGE 5
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 9.6. Low Center Left Rear Camera Mount (FNOL) – Wheellift This section describes the installation procedures for Exterior Rear Camera on a wheellift vehicle. Mounting Examples Low Center Left Rear Sample Camera Views No vehicle Loaded vehicle Installation Steps 1) Position the camera in the chosen location and mark holes for mounting screws and for camera cable pass-through into vehicle.
PAGE 6
Vehicle Monitoring and Locating System Tow Truck Installation Procedures Mobile Video Computing Solutions LLC 2) Drill holes for self-tapping sheet metal screws and for the camera connector. 3) Mount the camera to the vehicle using sheet metal screws. 4) If the MDVR isn’t powered up yet, don’t securely tighten the camera aiming screws until the camera aiming step later.