Product Manual

ManualsBrandsMobile Technologies ManualsElectronicsConnect Hub Repeater

MTI CONNECT

PoE NETWORK EXTENDER PRODUCT MANUAL

1 2

NOTE: This device requires professional installation

to prevent tampering with or removal/replacement of

the antenna by anyone other than qualiﬁed service

professionals.

Choose an appropriate location, preferably on the ceiling,

within 70 ft of the MTI Connect

Hub or another network

extender.

70 ft

Cable length not to

exceed 100m (330ft).

NOTE: PoE

Network Extender

must be powered by an

ES1 (<60 VDC) and PS1 (<15W)

PoE

power source.

Passive and Active

PoE

adapters are supported.

Run a Cat5e cable to the chosen location. Cable must be

terminated with an RJ-45 Connector following

TIA-568 A/B standards. Connect one end of the cable to a

PoE adapter.

NOTE: Cat5e cables and PoE devices should

be installed by certiﬁed professionals, following

installation standards deﬁned by local electrical code.

Plug the Cat5e cable’s RJ-45 connector into the PoE

Network Extender’s RJ-45 jack and route the cable as

desired, using the provided cable channels if needed.

Mount the extender using the 3.5 mm x 16 mm screws

(or longer if needed) for the mounting surface (not

included).

PoE Adapter

MOUNTING

3 4

Summary of content (5 pages)

PAGE 1
MOUNTING MTI CONNECT® PoE NETWORK EXTENDER PRODUCT MANUAL 1 NOTE: This device requires professional installation to prevent tampering with or removal/replacement of the antenna by anyone other than qualified service professionals. Choose an appropriate location, preferably on the ceiling, within 70 ft of the MTI Connect® Hub or another network extender. 2 NOTE: PoE Network Extender must be powered by an ES1 (<60 VDC) and PS1 (<15W) PoE power source. Passive and Active PoE adapters are supported.
PAGE 2
NETWORK PAIRING MTI CONNECT® PoE NETWORK EXTENDER PRODUCT MANUAL ® in pairing mode by 1 Place the MTI Connect Hub ® inserting an MTI Connect Unified IntelliKey into the USB Mini connector on the top of the MTI Connect® Hub. After 10 seconds the System Status LED will begin flashing blue, indicating the Hub is in Pairing mode. 2 Press the recessed Pairing Button (labeled) shown below for two seconds. The Network Extender Status LED will begin flashing blue, indicating it has entered pairing mode.
PAGE 3
FUNCTIONALITY MTI CONNECT® PoE NETWORK EXTENDER PRODUCT MANUAL Reserved for future Pairing Debug port, for authorized use technician use only 1.22” (31.10mm) 5.98” (151.9mm) PoE RJ-45 Input 5.28” (134.00mm) 0.21” (5.4mm) www.MTIGS.com | T:800.426.6844 Status LED 3.59” (88.
PAGE 4
LED STATUS INDICATORS Visual Reference MTI CONNECT® PoE NETWORK EXTENDER PRODUCT MANUAL System Status No Lights On Status LED Solid Green Network Extender has no power and backup battery has been depleted. Reconnect Network Extender to power. Network Extender is fully functional: – Mesh network communication is good Status LED Flashing Blue Network Extender is in mesh pairing mode.
PAGE 5
FCC STATEMENT MTI CONNECT® PoE NETWORK EXTENDER PRODUCT MANUAL FCC ID: 2AA2X-15000242 Model: PoE Network Extender FCC Statement This device complies with Part 15 of the FCC Rules. Caution: If any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.