PLUNGER LOCK PARTS MTI PLUNGER LOCKS™ PRODUCT MANUAL Plunger Lock Body Latch Battery installation on page 8. Battery Latch VHB Mounting Template A Mounting Template B Latch Spacer Screws Latch Spacer D Latch Spacer E Latch Spacer F Keys not included. See Page 4. www.mobiletechinc.com | T:800.426.
KEY SETS (SOLD SEPARATELY) Key Starter Set – 185-00459 MTI PLUNGER LOCKS™ PRODUCT MANUAL User Key Bulk (x5) Pack 185-00460 Connect Card 401-00008 x5 x1 x1 x2 KEY REGISTRATION (Complete ALL programming before installing) 1 Swipe Authorization card to enter enrollment mode. You will hear a double beep tone, indicating enrollment mode has been entered. 2 Swipe each User card to lock. A double beep tone indicates a card is now enrolled. Repeat for each user card, up to 250 user cards.
INITIAL SET UP MTI PLUNGER LOCKS™ PRODUCT MANUAL Converting to Connect Lock To use the MTI Connect Business Intelligence feature of your MTI locks you must have an internet connection, a MTI Connect Hub to create the mesh network, and the MTI Connect Card, which allows you to convert modes. In Connect mode, the lock will check in with the Hub every hour, and every time a lock is accessed. During check-in, the Hub will look for new key white list, report lock status, battery status, and lock ID. 1.
ATTACHING SPACERS MTI PLUNGER LOCKS™ PRODUCT MANUAL 1 Insert the gauge into the gap between the front and back 2 The letter closest to the edge behind the front panel 3 Secure the spacer to the latch using the two included 4 Apply adhesive to the back of the spacer or to the back panel doors. screws. indicates the spacer required to fill the gap. “A” does not require an additional spacer. of the latch if the spacer is not used. OR www.mobiletechinc.com | T:800.426.
INSTALLATION 1 Ensure that keys have been correctly registered and locks have been completely set up before installing. Fully close the sliding doors. 3 Open the sliding doors to fully expose the latch template, which will aid in placement. www.mobiletechinc.com | T:800.426.6844 MTI PLUNGER LOCKS™ PRODUCT MANUAL 2 Place Template A on the back panel and slip it between the panels.
MTI PLUNGER LOCKS™ PRODUCT MANUAL 5 Place the latch into the opening on the template taped to 6 Slide the remaining door so lines up with the line on 7 Peel VHB on the back of the lock body. 8 Place the lock body in Template B, ensuring that the the back cabinet door’s surface. Template A. Place Template B on the front door so it lines up with Template A. Remove Template A latch on the back is flush to the edge of the door. Remove Template B.
FCC STATEMENT MTI PLUNGER LOCKS™ PRODUCT MANUAL FCC ID: 2AA2X-15ØØØ11824 Model: Plunger Lock FCC STATEMENT This device complies with Part 15 of the FCC Rules. Caution: If any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
LOCK REMOVAL MTI PLUNGER LOCKS™ PRODUCT MANUAL 1 2 3 BATTERY Battery Caution Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Remove batteries of uninstalled locks before storing. CORRECT DISPOSAL OF PRODUCT This marking indicates that this product should not be disposed with other household wastes throughout the EU.