Stealth X6 4G LTE Extreme Power Building Boosters X660 X665 X672 6 BAND MULTI BAND Building 60 -72dB BBUX6 Series USA User Manual Cellular RX/TX 60-72dB 6 BAND Signal Booster MULTI BAND 60-72dB Extreme Power Building Booster 2G, 3G, 3G+, 4G, 4G+ GSM,HSPA,CDMA,LTE, LTE A Band 12,17 Band 13 Band 5 Band 4 Band 2,25 700MHz Lower 700MHz Upper 850MHz 1700/2100MHz 1900MHz ext model shown: BMUX660 stealth tech ® In 2001 SmoothTalker produced the first digital mobile cellular signal booster in North Am
Contents Inside Antenna SEMDP1 Cellular Booster Optional outside antennas SEMDP1 Power supply SEMDA2 SEMO NOTE: Only one of the outside antennas is included in this kit (check model) All kits include necessary brackets and co-axial cables for assembly. It is normal for the booster to be quite warm during operation.
Approved Equipment List For specifications of any of the Smoothalker FCC approved part numbers listed below visit smoothtalker.com FCC requirements prohibit the use of unauthorized Antennas, Cables, and/or Coupling devices. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 8 inches from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
1) Installation: Connect the inside antenna and the outside antenna as shown in Fig. 1, Pg. 4. 2) Outside antenna: a) Place outside antenna outside of the house in the area that has the best signal. b) If outside location is unavailable, place the outdoor antenna on a window with the best signal. 3) Inside Antenna: Connect the inside antenna as shown in Fig. 1, Pg. 4. 4) Separation: Increase the distance of the outside and inside antenna as much as possible to maximize coverage and avoid gain reduction.
Typical Installation (Fig. 1 ) (All parts are included in Booster kit.) Fig. 1 Optional Dual Inside Antenna Installation (Fig. 2 ) (Additional parts required which are not included in Booster kit.) Fig.
LED Lights Explanation and Troubleshooting The LED lights on the booster face plate indicate the operating gain state of the booster. The Green and Orange lights indicate the gain status in each operating band When Both Green and Orange LED's are “SOLID ON” it means that the booster is operating normally with full gain (No Automatic Gain Reduction) When one or both of the LEDS are flashing (Per the chart on Pg.
Understanding the LED Indicators Hp Att Osc Att RX High Power Attenuation Oscillation Attenuation Band Frequency Band 12, 17 Band 13 Band 5 Band 4 Band 2, 25 700MHz Lower 700MHz Upper 850MHz 1700/2100MHz 1900MHz ext Green LED Orange LED LED Lights Status Explanation Attenuation (Att) Each flash indicates up to 3dB of gain reduction also known as gain attenuation. For example: three flashes equals 9dB of attenuation.
Operational description: To comply with FCC NPS (Network Protection Standard) requirements: NPS and other compliance/safeguard features for AGC and anti-oscillation have been implemented. NPS and other compliance/safeguard features are defaulted to be “On” (in operation). NPS and other compliance/safeguard features can not be field reconfigured, disabled or removed. This booster is not user programmable, does not need fine tuning or adjustment, does not require professional installation.
