User's Manual

Device Overview
How to wear your Q-68HR?
User ManualQ-68HR
Q-Band
EN
Wear Q-68HR on your wrist
1 2
3 4
Charge your Q-68HR
Fasten Q-68HR with clasp
Change the wristband
Put on the wristband with the screen facing up and the band wrapped
around your wrist. Slide one band through the loop of the other band, and
align the clasp along the band to find the holes where best fit the clasps.
Squeeze both clasps into the holes on the wristband until you hear a
click, indicating the band is securely fastened.
Note: The watch band is replaceable and both side wearable/reversible.
Spread open both bands with the screen facing up, and press down the screen
with your thumb until the core comes off the wristband.
Insert the core with screen facing up into the notch from below the wristband.
Make sure the two tenons on each side of the core are securely fixed into the
corresponding slots in the bands.
Important Notice:
Failure to follow the instructions above might cause damage to the device.
1.
2.
1
2
3
2
Reversible Wristband Clasp
Core Touch Button
Metallic contact for charging
Optical Sensor
To charge your Q-68HR, place it in the charging box at the
other end of the USB cable. Close the box afterwards, and
make sure the Q-68HR is securely covered. Plug the USB
connector to either a PC or power adapter to start charging.
1