User's Manual

Q-62HR
Q-Band
EN
User Manual
Device
Overview
Clasp
Wristband
Core
Button
Metallic contact for charging
How to wear your
Q-62HR?
1
Wear Q-62HR on your wrist
2
Fasten Q-62HR with clasp
Put on the wristband with the screen facing up and the band
wrapped around your wrist. Align the clasp along the band to
find the holes where best fit the clasps.
Squeeze both clasps into the holes on the wristband until you
hear a click, indicating the band is securely fastened.
3
Charge your Q-62HR
4
Change the wristband
1
2
To charge your Q-62HR, place it in the charging box at the
other end of the USB cable. Close the box afterwards, and
make sure the Q-62HR is securely covered. Plug the USB
connector to either a PC or power adapter to start charging.
1. Spread open both bands with the screen facing up, and press down
the screen with your thumb until the core comes off the wristband.
2.
Insert the core with screen facing up into the notch from below the
wristband. Button up the clasp on the side of the band with 2 holes.
Please note that the charging contact should be near the clasp.