70204 MOBICAM DXR 680 680 130 270 1050 2100 15 PWR.
70204 camera and Installation Camera receiver Receiver battery pairing operation receiver camera camera receiver camera camera camera receiver receiver camera camera receiver camera 3.5 receiver camera and receiver 2 Mounting kit Press power key to resume receiver image, please refer to [Power Saving] section at page 12 for details.
camera receiver receiver camera receiver 13
Alarm Setup Camera Press PWR. DC IN 5V/1A Lens IR LED Link indicator Power indicator Battery indicator Power key 13 DC IN jack 13 Camera stand / to move between the items. Event List U SB Receiver to shift to on /off. Press VOX alarm ON: The receiver will give an alarm for 15 seconds when the camera is triggered by voice. Battery low alarm ON: The receiver will give an alarm for 15 seconds when the camera battery is low.
VOX Sensitivity and Installation Camera Connection 1 Connect power cable to camera’s DC IN then plug on switching power supply adapter to wall outlet. Use / 2 to adjust VOX sensitivity level. 2 Push [Power Button] once to turn ON the camera. Built- in Lithium battery charging process starts automatically by plugging OFF --VOX funtion will be disabled. level 3 means high sensitivity,level 1 means low sensitivity in switching power supply.
Pairing Camera Step 2: Basic Operation I. Knowing Camera Function Buttons and Indicators 1. Use to select a channel. 2. Press to start system countdown from 60 seconds. 3. Within 60-second countdown, press PAIR at the camera side. Image will display when pairing is complete. PWR. 1 DC IN 5V/1A Power Saving [Battery Indicator] Green LED = Battery Charging; please charge battery until Green LED goes off.
Camera On/Off USB II. Know Receiver Function Buttons and Indicators Use / press to select the camera you need to turn off, to change ON/OFF status. 1 Make sure available cameras are set to ON for SCAN or QUAD mode [Battery Indicator] 1 Green LED = Battery Charging; please charge battery until Green LED goes off. Red LED = Battery Low; Camera is turning OFF in 3-minute time, please plug on switching power Scan Period supply for charging and continuous use. 2 LED OFF = Battery Fully Charged.
Step 3: Advanced Operation I. Knowing Screen Icons Time Setting 92; a hi b c d e f g j i a. Signal indicator b. Current display channel indicator c. ---SD card available ---SD card locked(flashing) ---SD card full(flashing) ---SD card error(flashing) d. Recording indicator(flashing) e. VOX (Voice-activation) triggering record ON f. VOX (Voice-activation) triggering alarm ON g. Camera battery low indicator h. Push-to-talk indicator i.
The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operated in conjunction with any other antenna or transmitter. FCC NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.