Installation Guide

RETRACTABLE SCREEN
DOUBLE INSWING
ASSEMBLY AND INSTALLATION INSTRUCTIONS
STEP 2: ASSEMBLY PREPARATIONS
Very important! Please examine the picture at right for additional
details. See Figure 2A >
Before proceeding to assembly, please look at the back of the
header and sill screen tracks. There you will find the numbers
6/0, 5/4 and 5/0 printed on each end of the track. These
numbers correspond to the door unit size that the screen will
fit onto.
Depending on the size of the door unit on which this system is
being installed, you may need to cut BOTH ENDS on the line
that corresponds with your door unit size. NOTE: the 6/0 size
DOES NOT require cutting.
IF YOU HAVE A 5/4 OR 5/0 DOOR
For 5/4 or 5/0 doors, you will need to cut the
header and sill screen tracks AND the header and sill screen
track covers on both ends.
Using a hacksaw, saw the header screen track on the line 5/4 or
5/0 - that corresponds to your door size.
FIG. 2A
FIG. 2B
6/0 5/10 5/4 5/0
NOTE: the track must be cut on both sides. Repeat for the sill
screen track. See Figure 2B >
Now, saw the header and sill screen track covers to match.
NOTE: the screen track covers do not have clear tape with 5/4 or
5/0 markings. You will need to cut the screen track covers
to match the NEW width of the header and sill screen tracks.
Page 2 of 7