User's Manual

IMG01 IMG02
1. Place the iPhone on this products cradle, adjust the cradle to
fit the iPhone securely. and Connect the iPhone to this products
30pin connector. (as IMG01)
2.Now use the 3.5 stereo cable to connect the iPhone and this
products for audio.(as IMG02)
3. Now you can select to talk or continue to enjoy music
through car speaker systems .
Work with iPhone
1. Place the device on this products cradle, and adjust the
cradle to hold the device securely.
2. Use the 3.5 stereo cable to connect your device and this
products for audio.
Using with others mechanisms
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including
interference that may cause undesired operation.
changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for
help.
RULE STATEMENT
1. Please use a clean soft cloth to clean this device.
2. For prolonged use of the device, device should be
disconnected from vehicle cigarette lighter port.
MAINTENANCE ATTENTION TO THE ISSUES
Please reference below for troubleshooting help with your
device.
1. Power indicator light does not emit
TROUBLESHOOTING
Connect your USB device to this products USB port to charge
your device.
USB Charger
All specifications are subject to change without notice.
SPECIFICATIONS
Please make sure your device has audio playback.
Please check if your USB device supports the standard.
Frequency
Band FM Frequency
Quality Hi-Fi stereo
Range 88.1~107.9MHz
Interval 0.1MHz
Power
Working Voltage: DC 12V ~ 24 V
USB Output Voltage: DC 5V 800mA
Stability 10ppm ( -10℃ ~+ 55℃)
Clutter & Harmonic ≤-60dB
Effective Range About 5m
Remote Range ≥3m
Audio
Stereo separation 40dB
Frequency reponse 20Hz~16KHz
Physical
Product size 110 x 65,5 x 40 mm
Weight 191 g
Audio Distortion
≤0.1%（F=75KHz，f=1KHz）
SNR: ≥45dB（1KHz 100%）
SYMPTOM SOLUTION
Fuse Spec: Φ5 x 20mm, 250V/2A
2. Cars speaker volume is too low
SYMPTOM SOLUTION
Please avoid using local radio signal frequencies to ensure
better sound quality.
Please adjust the volume on the device or the car stereo to
ensure proper volume levels.
Please carefully check the electricity capacity of your
equipment when using as a USB charger
WARNING
WARRANTY WILL BE VOIDED IF MODIFICATIONS OR
ALTERATIONS HAVE BEEN MADE TO THE DEVICE.
DEVICE CONTAINS REMOVABLE PARTS PLEASE
MONITOR WHEN AROUND CHILDREN.
Not fully inserted into the
car cigarette lighter hole
The volume of audio
device is too low
Adjust the device volume
higher
Car Speaker volume is too
low
Adjust the car volume
Bad contact of audio
Recheck if audio stereo
cable is securely plugged
Stereo cable is damaged Replace with a new one
3. There is static from the car speaker
SYMPTOM SOLUTION
Strong local radio signal
interference
Change the frequency
7. No sound coming from the car speaker
SYMPTOM SOLUTION
Device setting is mute or
has stopped
Check the device settings
4. There is an echo when using with the iPhone
SYMPTOM SOLUTION
Volume is too high
Adjust iPhone or car
6. USB device is not charging
SYMPTOM SOLUTION
Use of non-Standard
Replace with a standard
Non-Standard USB
Stop the charging
5. Audio output on one side is lower than the other when using
the iPhone
SYMPTOM SOLUTION
User is to far away from
the iPhone
FM RADIO TRANSMITTER uses the iPhone MIC,
effective speaking distances should be around l M
User needs or maintain no
more than l M distance for
effective hands-free
Fully inserted into the car
cigarette lighter hole
4 5 6
iPod & iPhone is a trademark of Apple Computer Inc.,
registered in the U.S. and other countries
PRODUCTS FEATURES
* Hi-Fi FM stereo transmitter allows you to fully enjoy your music.
* Cigarette Lighter power supply mode.
* Suitable for all iPhone & iPod / all Car / all MP3 player.
* Supports iPhone hands-free feature through your car
speaker system.
* Support charging and FM transmitter simultaneously.
* Support mobile phone and GPS charging with output USB
socket.
* LCD frequency display with backlight for easy to read display.
* Adjustable arch design.
* High quality silicone fixer prevents the this products from rotating.
* The flexible goose-pipe makes it convenient to find the
best position for your device. It is compatible in the
worldwide. Goose-pipe with rotation prevention design
keeps your devices steady & firm in its position.
1. Silicone Fixer: Prevents this products from rotating.
2. Cigarette Power Adapter: Insert into the cigarette lighter hole.
3. LED Power Indicator Light: Indicates operating status.
4. Flexible goose pipe: for easy positioning.
5. iPod 30 Pin Connector: For use with iPhone and iPod.
6. Adjustable Feet: Keeps your device down.
7. Release Button: Release your holder.
8. Adjustable Holder: To hold your device.
9. Silicone Protector: Protect your device from being scratched.
10. 3.5 Audio Input Hole: External audio input.
11. Screw: Adjust tightness.
12. USB Port: Output voltage DC 5V 800mA.
13. “▼”: Frequency decreases.
14. “▲¨: Frequency increases.
15. LCD panel: display FM frequency.
16. “QS”: quick set.
1. Insert the cigarette power adapter into the car’s cigarette
lighter. Now adjust this products to a suitable position and then
put your device onto the cradle.
Press “▲” or “▼” button to adjust the frequency you wish to
use or press the “QS” button to use the default frequency.
2. Turn on the cars FM radio band and adjust to the frequency
as set on this products.
Thank you for purchasing this Products.
Please carefully read this instruction manual for properly
setup instructions.
Compatible with iPod/iPhone/MP3/MP4
USER MANUAL
FM Transmitter
12
3
4
5
6
7
8
9
10
11
12
13
14
15
16
DEVICE APPEARANCE
STANDARD ACCESORIES
·3.5 Stereo cable
OPERATING GUIDE
Preparation for usage
1. Place the iPod on this products cradle, and adjust the cradle
to hold the iPod securely.
2. Connect the iPod to this products 30pin connector. Now
use the 3.5 stereo cable to connect the iPod and this products
for audio.
Work with iPod
Press and hold “▲” or “▼” button to scroll through
the different radio frequencies
1 2 3