User's Manual

ManualsBrandsMitsumi Electric ManualsElectronicsWireless LAN module

User Manual

MITSUMI WiFi Module

MODEL DWM-W078

The purpose of this manual is to explain correct way how to integrate module

DWM-W078 to the end product. It includes procedures that shall assist you to avoid unforeseen problems.

This manual presents information that shows how module and OEM product, where module integrated,

complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer

could void the authority to operate in these regions.

The MITSUMI WiFi Module, model DWM-W078 has to be installed and used in accordance with the

technical description/installation instructions provided by the manufacturer.

For detail information concerning type approval of this module(e.g. where this module is already

pre-approved) please contact the authorized local distributor or the manufacturer.

The system may only be implemented in the configuration that was authorized.

Note that any changes or modifications to this equipment not expressly approved by the manufacturer could

void the user’s authority to operate this equipment.

Summary of content (4 pages)

PAGE 1
User Manual MITSUMI WiFi Module MODEL DWM-W078 The purpose of this manual is to explain correct way how to integrate module DWM-W078 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions.
PAGE 2
Regulatory Information Operational information Wireless interoperability The end product integrating this module is designed to be interoperable with any wireless LAN product that is based on direct sequence spread spectrum(DSSS) and orthogonal frequency division multiplexing(OFDM) radio technology and to comply with the following standards. IEEE Std 802.11b Standard on 2.4GHz Wireless LAN IEEE Std 802.11g Standard on 2.4GHz Wireless LAN IEEE Std 802.11n Standard on 2.
PAGE 3
USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
PAGE 4
Instructions to OEM integrators A User manual provided to the end user must indicate the operating requirements and conditions that must be observed to ensure compliance with the above-mentioned FCC RF Exposure guidline. If this module is intended for use in a portable device, integrators are responsible for separate evaluation and/or approval to satisfy FCC RF Exposure requirements. The antenna used this module is as follows; Antenna type: Chip antenna Antenna gain: -9.