User's Manual

ManualsBrandsMitsumi Electric ManualsElectronicsWiFi Module

User Manual

MITSUMI WiFi Module

MODEL DWM-W014

The purpose of this manual is to explain correct way how to integrate module

DWM-W014 to the end product. It includes procedures that shall assist you to avoid

unforeseen problems. This manual presents information that shows how module and

OEM product, where module integrated, complies with regulations in certain regions. Any

modifications, not expressly approved by the manufacturer could void the authority to

operate in these regions.

The MITSUMI WiFi Module, model DWM-W014 has to be installed and used in accordance

with the technical description/installation instructions provided by the manufacturer.

For detail information concerning type approval of this module (e.g. where this module is

already pre-approved) please contact the authorized local distributor or the

manufacturer.

The system may only be implemented in the configuration that was authorized. Note that

any changes or modifications to this equipment not expressly approved by the

manufacturer could void the user’s authority to operate this equipment.

Summary of content (6 pages)

PAGE 1
User Manual MITSUMI WiFi Module MODEL DWM-W014 The purpose of this manual is to explain correct way how to integrate module DWM-W014 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions.
PAGE 2
Regulatory Information Operational Information Wireless Interoperability The end product integrating this module is designed to be interoperable with any wireless LAN product that is based on direct sequence spread spectrum (DSSS) and orthogonal frequency division multiplexing (OFDM) radio technology and to comply with the following standards. ･IEEE Std 802.11b Standard on 2.4GHz Wireless LAN ･IEEE Std 802.11g Standard on 2.
PAGE 3
USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
PAGE 4
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 5
Canada-Industry Canada (IC) This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
PAGE 6
Europe-EU Declaration of Conformity and Restrictions Hereby, MITSUMI declares that this Mitsumi WiFi module DWM-W014 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. This equipment is marked with the symbol and can be used throughout the European community. This indicates compliance with the R&TTE Directive 1999/5/EC and meets the relevant parts of following technical specifications: EN 300 328 V1.7.