User Manual DR237973
Important Information This document provides you with important information about the safe use of your DR237973 Development kit. Please read this information carefully, and keep this document for future reference. This development kit is provided to you under the terms of your DR237973 Development Kit License and may be used only in accordance with the License. DR237973 is sold to professional developers only. DR237973 is not sold for consumer market.
Product Specification This DR237973 development kit is the controller for master console system. - Set up 1. Prepare the DR237973 and the console. 2. Connect USB cable to the DR237973 to charge battery. 3. Start up the console. 4. Press [SYNC] button. 5. The Blue LED will turn on and DR237973 will be able to use for the console system.
- Usage This device is used as shown below, holding in hands in front of body. Control the buttons with your thumbs. Do not put any person or thing between this device and the master console since there is wireless communication.
Exposure to Radio Frequency Energy DR237973 contain radio transmitter and receiver. When on, this development kit sends and receives radio frequency (RF) energy through its antenna. In order to comply with FCC radio-frequency radiation exposure guidelines for an uncontrolled exposure, this device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC Compliance Statements Caution: Any changes or modifications not expressly approved by the party responsible for product compliance could void the user's authority to operate the equipment. This device must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with part 15 of the FCC rules.
This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device. The term “IC” before the equipment certification number only signifies that the Industry Canada technical specifications were met.