User's Manual

ManualsBrandsMitsubishi Electric ManualsComputers & AccessoriesDigital Color Printer

OTHERSPRECAUTIONS FEATURES

PREPARATION

TROUBLE-

SHOOTING

CONTENTS

BEFORE OPERATION

CONNECTION WITH USB DATA SIGNAL EQUIPMENT

CONNECTING TO PERSONAL COMPUTER (EXAMPLE)

Check that the printer is turned on before connection.

Turn on the power of a personal computer.

Install the printer driver.

• Do not yet connect the printer to a personal computer.

NOTE

Connect the printer to a personal computer as shown below.

To USB port

Personal computerDigital color printer

• A USB cable is not supplied with this unit. Use the USB 2.0 certied cable of 2 m or less in length.

NOTE

PRINTER DRIVER INSTALLATION

The printer driver is required to print the data from the personal computer connected with this unit.

The printer driver for Windows

is supplied with this unit.

Microsoft and Windows are the trademarks or the registered trademarks of Microsoft Corporation in the U.S.A. and other

countries.

• Refer to the following website to check the latest version of the printer driver and the printer information.

http://www.mitsubishielectric.co.jp/ldg/ja/products/visual/lineup/printer/photo/download_01_english.html

NOTE

Summary of content (5 pages)

PAGE 1
BEFORE OPERATION CONNECTION WITH USB DATA SIGNAL EQUIPMENT PRECAUTIONS CONNECTING TO PERSONAL COMPUTER (EXAMPLE) Check that the printer is turned on before connection. Turn on the power of a personal computer. Install the printer driver. • FEATURES NOTE Do not yet connect the printer to a personal computer. Connect the printer to a personal computer as shown below.
PAGE 2
ERROR MESSAGES AND COUNTERMEASURES INDICATIONS ON THE FRONT PANEL AND COUNTERMEASURES : Steady on ALARM PAPER RIBBON POWER : Off Causes and Countermeasures : Blinking Page The printer is in the standby mode. 7 The printer is in the power save mode. When the printer is idle for an extended period, it automatically enters the power save mode from the standby mode, reducing power consumption. It may take time that the printer is ready to print images after the image data is sent.
PAGE 3
ERROR MESSAGES AND COUNTERMEASURES OVERCOMING PAPER JAMS PRECAUTIONS Press the OPEN button to open the printing unit. Make sure that the power is turned on before opening the printing unit. FEATURES OPEN button Remove the ink cassette. PREPARATION Remove the paper strip bin and then pull the knob to open the door. Knob TROUBLESHOOTING Pull out the defective part of the print paper to the direction of an arrow. OTHERS Cut off the defective part of the print paper with scissors.
PAGE 4
ERROR MESSAGES AND COUNTERMEASURES REPAIRING A TORN INK RIBBON PRECAUTIONS Position the ink cassette with the torn ink ribbon on a flat, clean surface. Place a piece of transparent adhesive cellophane tape on the center of the ink ribbon. Cellophane tape FEATURES Install the ink cassette in the printer. TROUBLESHOOTING Wind the shaft of the ink ribbon in the direction of the arrow so that the cellophane tape is not seen.
PAGE 5
ERROR MESSAGES AND COUNTERMEASURES BEFORE CALLING FOR SERVICE Symptom PRECAUTIONS  For the following symptoms, check the unit again before calling for service. Check & Remedy The printing unit doesn’t open. Are you turning off the power during printing procedure? → Turn on the power and then open the printing unit. The image is not printed. Is the PAPER RIBBON indicator or the ALARM indicator illuminating or blinking? → Refer to “Overcoming paper jams.