Since this device is always used with vehicle, it is not sold to general end users separately. Therefore there is no user manual of this device by alone. This document is an excerpt from a user manual of vehicle.
FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC/IC This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
SMART KEY SYSTEM EAU61660 1 2 3 4 5 6 7 Smart key system The smart key system enables the following operations to be carried out without using a mechanical key. Power “ON/OFF” Engine start and stop Steering lock release and locking Seat lock release TIP To preserve battery power, the smart key will turn off automatically about a week after the vehicle is last used. Turn the smart key on before using the vehicle again.
SMART KEY SYSTEM EAU61640 Handling of mechanical key and smart key 1 2 3 4 5 EWA17950 WARNING The smart key should be carried by the driver. Do not store it on the vehicle. When the smart key is within operating range, exercise due care because other people not carrying the smart key can also start the engine or operate the vehicle. Included with the vehicle are one smart key, one smart key identification tag, one mechanical key and one mechanical key identification tag.
SMART KEY SYSTEM 1 2 3 4 5 6 7 8 9 10 get wet. Do not put heavy objects on top of the smart key. Do not leave the smart key in a place exposed to direct sunlight, high temperature, or high humidity. Do not cut, drill, or attempt to modify the smart key. Keep the smart key away from strong magnetic fields and magnetic objects such as key holders, TVs, and computers. Keep the smart key away from electric medical equipment.
SMART KEY SYSTEM the smart key is brought within range of the vehicle. Turn the key on (activate it) and bring it within range to operate the vehicle. EAU61600 How to replace the battery of the smart key Please replace the battery with in the following situations. The key signal light flashes for about 20 seconds when the power of the vehicle is turned ON. When the smart key system does not receive signals sent from the smart key. 1 1.
SMART KEY SYSTEM 1 5. Replace the battery with a new one. 2 Battery used: Button battery CR2025 × 1 unit 3 2 4 5 1 1 2 7 To release the seat lock Inserti the mechanical key into the lock inside front storage compartment B and turn it clockwise. 6. Attach the cover of the battery. 7. Re-assemble the smart key. 9 12 The mechanical key can be used when the smart key is lost or its battery is discharged, or whenever the smart key system is not operating normally.
SMART KEY SYSTEM the rear storage compartment or lock it in front storage compartment B. In the event of an emergency, you will need the mechanical key to unlock the seat lock, access the rear storage compartment, and operate the vehicle in emergency mode (see page 6-1). EAU61580 Operating range of the smart key system The operating range of the smart key system is about 0.8 m (3.15 in.) from the center of the handlebars.
SMART KEY SYSTEM EAU61630 1 2 3 Vehicle power ON and steering lock release 1. With the smart key in operating range and the vehicle in the unlocked state, press the start switch for at least one second. 4 5 6 and then operate the steering unlock function again. If the steering continues to be locked and will not release, the key signal light will flash 16 times and the steering lock release operation will stop midway.
SMART KEY SYSTEM Please refer to the emergency EAU61690 Powering off the vehicle To turn the vehicle off, have the smart key unlocked (on) and within operating range, press the OFF/steering lock switch. The smart key system will sound once to confirm that the vehicle has been successfully turned off.
SMART KEY SYSTEM EAU61610 1 2 3 4 5 6 7 8 EWA14742 How to steering lock After turning OFF the power of the vehicle, move the vehicle to a safe parking place. Turn the handlebars fully to the left and then press the OFF/steering lock switch for at least one second. TIP If the steering lock function locks as normal, the system will sounds once. If the steering lock function does not lock correctly, the system will sound for three seconds and the key signal light will flash.
SMART KEY SYSTEM EAU61590 Parking mode The steering is locked, and the hazard lights and turn signal lights can be turned on, but all other electrical systems are off. To close the seat, lower the seat and push it down to lock it in place. TIP Make sure the seat is properly closed before starting off. The seat can be opened mechani- cally in the event of an emergency. See emergency mode on page 6-1 for more information. To use the parking mode 1. Lock the steering. (Refer to Page 3-9) 2.