Installation Guide

Installation Guide
Modem Fiber Optic
Modem Fiber Optic
Adaptor
Cable
Installation Guide
Content
Installation explantion
Set up telephone
the fiber optic cable that connects your
We advise you not
Attention
device is very delicate.
to pull it hard to avoid broken.
Power on Optical Fiber Optic
To turn on the Modem you must press the ON OFF switch
located on the back of the device.
blue
blue
blue
status
Telephone service is availableTelephone service is available
Telephone service is available
Wi-Fi interface function correctly
Connect with internet
Movistar modem provides optimize internet configuration
installation, a remote update of the software of your device to offer you a better service
Movistar can automatically perform at some time, especially at the first
and operation. During this process the LEDs will flash and after a few minutes the
Installation and connection of the indicator lights will remain as in the previous table if
everything worked correctly. If a red light comes on, it means that there is abnormal
operation of the equipment. If so, we recommend that you turn off and on the device
(quiet because you will not lose your network configuration). If the problem persists
you can perform a factory reset or contact the Movistar service lines.
Connect the Fiber Optic cable to the Fiber Optic port of the device (1) and then
Use a telephone cable to connect the device's Telf port (2) with a telephone socket
Plug the power adapter into the mains and the connector of the DC port equipment
the other end to the Optical fiber socket of your home.
in your home (if you only use a landline, you can plug it directly into the device's Telf
port instead of using the jack).
while the update is taking place, as it could damage the system:12V-2A (3).
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference
Changes or modifications not expressly approved by the party responsible for compliance could
This product has been tested and complies with the
If this device does cause harmful interference to radio or television reception, which is found by turning
i. Reorient or relocate the receiving antenna
ii. Increase the separation between the equipment or devices
iii. Connect the equipment to an outlet other than the receiver's
iiii. Consult a dealer or an experienced radio/TV technician for assistance
received, including interference that may cause undesired operation.
void the user's authority to operate the equipment.
specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
according to the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
uncontrolled environment.
This transmitter must be at least 20 cm from the user and must not
Attention: This equipment complies with FCC RF radiation exposure limits set forth for an
be co-located or operating in conjunction with any other antenna or transmitter.