User's Manual Part 2

15
Authorized Users
Mobile Phone Requirements
Making your First Femtozone Call
FINAL CHECKS & MAKING YOUR FIRST CALL
The 9361 Home Cell V2 is configured to only allow service for authorized mobile
phones. The first mobile phone SIM card details you provided to your mobile phone
service provider is pre-configured to work with the device during auto-configuration.
To allow other users to connect to your 9361 Home Cell V2, you must register them
with your mobile phone service provider. The 9361 Home Cell V2 will only support
service to mobile phones registered for use on the same mobile phone network as
the 9361 Home Cell V2.
To add additional mobile users to your 9361 Home Cell V2 please contact your
Femtozone Service Provider.
3G compatible mobile phone
Enable and configure 3G service on your mobile phone. Details can be found in
your mobile phones user guide.
Enable 3G service with your mobile phone Service Provider to work with the SIM
card in your mobile phone.
Before you make your first call, make sure that your mobile phone is registered with
your Femtozone service and connected to the 9361 Home Cell V2.
Power OFF your mobile phone if your mobile phone was ON during the 9361 Home
Cell V2 installation process. Wait 30 seconds and then Power On your mobile phone.
After a couple of seconds your mobile phone should indicate that it is connected to
the Femtozone. If this is not the case please refer to the troubleshooting section of
this guide.
You are now ready to place your first call – just use your phone as you normally do
and enjoy the enhanced quality experience!
9361 Home Cell V2 - Getting Started Guide