User Manual

FCC ID: UOU69135RFP32U-01 IC: 1884E-69135000
RFP 32 US
- Important notes -
Modifications not expressly approved by this company could void the user’s
authority to operate the equipment.
Privacy of communications may not be ensured when using this device.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Exposure to Radio Frequency (RF) Signals:
The wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission (FCC) of the U.S.
Government and the Ministry of Health (Canada), Safety Code 6. These limits are
part of comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on the safety standards previously set
by both U.S. and international standards bodies. These standards include a
substantial safety margin designed to assure the safety of all persons, regardless of
age and health.
This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
The radiating element of the base station should be installed during operating at a
separation distance greater than 20 cm between user and device. The device
comply with the requirements for routine evaluation limits
710505.02, Rev. 02