User's Manual

UsermanualforNFCVAC

ModelnumberNFCVAC.

Contents

1.Introduction

2.SystemOverview

3.Installation

4.Operation

5.ComplianceStatements

6.TechnicalSpecification



1.Introduction

ThisdocumentistheusermanualfortheMitechIntegratedSystemsRFIDmodule–NFCVAC

ThismoduleisusedforMitechIntegratedSystemsproduct,which

isValueAddCenter(VAC)

ThismodulereadsRFTAGandprovidethisreadingtoVAC





2.SystemOverview

ThismodulereadsdatafromtheuserRFIDcards.AndprovidesitsreadingtoVAC.TheVACcanbe

installedindifferentcommercialplaces,whereRFIDcardsareusedandwhere

isinstalledotherMitech

IntegratedSystemsequipment.BasedonthereceiveddatafromtheNFCVACmodule,themainVAC’s

processorboardwillactivateitsperipheraldevices,likepaymentsystem,carddispensingandetc.The

moduleisconnectedtotheVACmainboardbyusingits5pinconnectorand5wirescable.



PAGE 1
User manual for NFCVAC Model number NFCVAC. Contents 1. Introduction 2. System Overview 3. Installation 4. Operation 5. Compliance Statements 6. Technical Specification 1. Introduction This document is the user manual for the Mitech Integrated Systems RFID module – NFCVAC This module is used for Mitech Integrated Systems product, which is Value Add Center (VAC) This module reads RFTAG and provide this reading to VAC 2. System Overview This module reads data from the user RFID cards.
PAGE 2
3. Installation The NFCVAC is installed following these steps: ‐ ‐ ‐ Obtain the module from the assemble line Install it on the back side of the door of the corresponding VAC Connect provided 5wires cable to the main controller board of the VAC After installing the module follow the test procedure of the VAC device 4. Operation After installing all components of the VAC, including NFCVAC module, the VAC is installed in the corresponding places for customer use.
PAGE 3
‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ‐ Consult the dealer or an experienced radio/TV technician for help. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In according with FCC part 15 the NFCVAC label shall contain the following statement: This device complies with Part 15 of the FCC rules.