BEAGLE CAMERA Quick Guide Manual
PACKING LIST Beagle camera Power Plug x1 Type C Cable 1.
SPECIFICATION Part Number Night Version Frame Rate Upload Printable File Beagle Yes Up to 25fps Yes, Only gcode files Compatibility of 3D Printers Marlin firmware Videos/Printable Files Storage Micro SD Card Connect to Printer USB Cable Video Compress H.264/H.265 Camera Resolution Up to 1080P Auto Time-lapse Video Temperature Monitor WiFi Connectivity Power Source Weight Yes Yes, for Hot End & Hot Bed Supports 2.4 GHz 802.
CAMERA INTRODUCTION 1 3 2 4 1 IR-Cut Sensor 2 Lens 3 Microphone 4 Camera Base
3 1 4 WiFi Printer 2 1 3 WiFi Indicator 2 Printer Indicator Solid Green: Solid Red: WiFi connected Printer connected Flashing Green: Flashing Red: WiFi disconnected Printed disconnected Speaker 4 USB Socket
1 2 3 1 Type-C Socket (Power) 2 Plug and hold for 5 seconds, and you will hear the voice of "Successfully resetting the camera", then the camera will be reset and restart.
CONNECTION Connecting Cables Plug the power cable into the camera and the power adaptor, then into a power outlet, plug the USB-Micro-B Cable into the camera and the 3d printer, as shown in the figure below. (The camera will take 1-2 minutes when power-up, don't cutoff the power during this period.) Power outlet Micro USB Connect to Printer Put on Camera Plug the USB-Micro USB cable into the camera and the printer, as shown in the figure above.
APP DOWNLOAD & REGISTRATION Beagleprint App Store Download Google Play Download APK Download Please scan the QR Code to reach the App download page, then download from App Store, Google Play or download the APK directly. After download,Click to run the app and make the registration. USE THE APP Use your phone to connect to the camera hotspot Connect the Camera to WiFi Network After power up the camera, click to run the “Beagleprint” app, then click “+” icon to add the camera.
Make sure the power is not being cut off during the configuration. XXXXXX XXXXXX Select your WiFi and then input the password to save the WiFi information in the app.
Go to the "Setting" interface of your mobile phone to connect the camera hotspot. The camera will automatically connect to the WiFi network. Please wait for 1-2 minutes.
Click the camera image to log in and then connect the camera to your printer. Click the “Connect” button to connect the camera to the printer, then you can control the printer through the camera.
ATTENTION Please DO NOT cut off the power of the Beagle camera when it's working; DO NOT disconnect the camera from the printer when it is connected to the printer and transmit printable files through the camera for 3d printing. Otherwise, it will cause printing failure and damage the camera's firmware. In this case, the camera cannot work typically; this problem is the user problem, not a quality problem.
FCC WARNING STATEMENT Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
GUIDELINES OF BEAGLE CAMERA Unboxing and Setup Setup for Time-lapse Video IP Address on PC Firmwave Ungrade 3D Printers of compatibility FAQ SHENZHEN MINTION TECHNOLOGY CO., LTD Webside: www.mintion.net Distribution: sales@mintion.net Support: support@mintion.