Instructions / Assembly
RC600 Frequency Programming
The hand held control System is equipped with learning frequency funcon which has 32 code
combinaons to prevent potenal interference from other remote units. The frequency on your
Receiver and Transmier units have been preset at the factory. (Fig 1). No frequency change is
necessary, should you decide to install another fan within the same home or area with a
separate frequency code please see the “frequency interference” trouble shoong secon to
learn how to change the frequency.
Frequency interference trouble shoong:
Soluon:
1. Turn the power off to your ceiling fan
2. Please use small tool to change the frequency seng on the control system.
3. Return power to the unit. Note: Aer the AC power is on, do not press any other buon
on the transmier before pressing the “Stop” buon, doing so will cause the procedure
to fail.
4. Within 60 seconds of turning the Fan’s AC power ON. Press the transmier’s STOP
buon for 10 seconds.
5. Once the receiver has detected the frequency, the down light of your fan will blink twice.
(There is no indicaon if your fan is not equipped with a light).
6. The receiver has now learned the frequency which has been selected on the transmier.
Aer compleng the steps above, you should be able to operate the ceiling fan and light.
If the fan is not responding to the transmier, please turn the power off to the receiver,
and repeat the process.