User manual

Thank you for purchasing NT-II.
Bluetooth Headset with NFC
NT-II
Charging the Headset:
1. Insert USB charging cable into a USB port that
supports 5V power output (e.g. AC/DC USB adapter
or PC USB port).
2. Connect charging cable to the Micro-USB
charging part of the NT-II headset.
3. Charging is in process when red LED light glows.
4. Charging is complete when blue LED light glows.
Powering On/Off:
Power On - Press and hold the Multifunction Key for
approx. 3 seconds. Release when blue LED light flashes.
Power Off - Press and hold the Multifunction Key for
approx. 5 seconds. Release when red LED light flashes.
Pairing Headset with Bluetooth Devices:
Enter Pairing Mode - Make sure the NT-II headset is
powered off. Press and hold the Multifunctioning
Key for approx. 6 seconds, release when red and blue
LED lights flash alternately.
Pairing Headset with Bluetooth Mobile Phone:
Make sure the Bluetooth function on your phone has
been enabled. Keep the NT-II headset and phone
within a 1 meter range when pairing.
1. Enter pairing mode on the NT-II headset (red and
blue LED lights flashing alternately).
2. Search for new Bluetooth devices on your phone,
after searching select ‘MINIX NT-2’.
3. According to the indication, enter password or PIN
No. ‘0000’, and the press ‘Yes’/’Confirm’ (depending
on your Bluetooth device settings).
4. After successfully pairing, select ‘MINIX NT-2’ in the
Bluetooth device list, and press ‘connect’.
5. After successfully connecting, the blue LED light
on the NT-II will continue to flash.
NT-II headset will automatically connect to last
connected device when powered on.
Pairing Headset with NFC Technology:
Make sure the NFC function has been enabled on
your device, and simply tap your NFC enabled device
to the assigned NFC location on the NT-II headset.
A pairing message will appear on the screen of your
device, press ‘Yes’ to complete pairing.
Tap the NFC mark again to disconnect device.
NT-II
Care & Maintenance:
Make sure to keep the headset dry at all times, and
away from water. NT-II headset is not waterproof,
contact with water will cause permanent damage
to the internals of the headset.
Do not leave the headset in direct sunlight or places
of extreme temperatures. Doing so will shorten
the lifespan of the headset, causing damage to the
internal battery and plastic casing.
Do not attempt to dismantle the headset. Any
attempts to modify, alter or repair the headset will
void the warranty.
Do not drop from excessive heights, doing so will result
in permanent damage to the headset.
Do not use intensive chemicals or detergents to clean
the headset.
Do not scrap the surface of the headset with sharp
objects to avoid causing permanent damage
to the plastic casing.
Technical Specifications:
Bluetooth CLASS 2, V3.0 + EDR
Compatible with Bluetooth profiles:
HSP, HFP, A2DP, AVRCP
Effective range: 10 meters
Speaker impedance: 32 ohm
Signal to noise ratio: > 93 +/- 3db
Frequency response: 20Hz - 20kHz
Polymer-Li Battery: built-in, 320mAh
Input: DC: 5V/160mA
Charge time: approx. 3 hours
Operating time: up to 10 hours of music
playback, up to 11 hours of talk-time
Standby time: up to 360 hours
Join the MINIX Forum at www.minixforum.com