User's Manual

ManualsBrandsMine Safety Appliances ManualsElectronicsRFID Tag Writer

TAL 507 (L) Rev. 0 © MSA 2005 Prnt. Spec. 10000005389(A) Mat. 10067066

Doc. 10067066

The warranties made by MSA with respect to the product are voided if the product is

not used and maintained in accordance with the instructions in this manual. Please

protect yourself and your employees by following the instructions. Please read and

observe the WARNINGS and CAUTIONS inside. For any additional information relative

to use or repair, write or call 1-800-MSA-2222 during regular working hours.

This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-

ing two conditions; (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation. Changes or modifications not expressly approved by the manu-

facture could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-

vide reasonable protection against harmful interference when the equipment is oper-

ated in a commercial environment. This equipment generates, uses, and can radiate

radio fr

equency energy and, if not installed and used in accor

dance with the instruc-

tion manual, may cause harmful interference to radio communications. Operation of

this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

THIS MANUAL MUST BE CAREFULLY READ AND FOLLOWED BY ALL PERSONS WHO

HAVE, OR WILL HAVE, THE RESPONSIBILITY FOR UPGRADING THE AIR MASK. This

Air Mask will perform as designed only if upgrading according to the Instructions.

OTHERWISE IT COULD FAIL TO PERFORM AS DESIGNED, AND PERSONS WHO RELY

ON THE AIR MASK COULD SUSTAIN SERIOUS PERSONAL INJURY OR DEATH.

SOFTWARE INSTRUCTIONS

ICM

Tx Unit Data

Program

Summary of content (4 pages)

PAGE 1
ICM Tx Unit Data Program ® SOFTWARE INSTRUCTIONS THIS MANUAL MUST BE CAREFULLY READ AND FOLLOWED BY ALL PERSONS WHO HAVE, OR WILL HAVE, THE RESPONSIBILITY FOR UPGRADING THE AIR MASK. This Air Mask will perform as designed only if upgrading according to the Instructions. OTHERWISE IT COULD FAIL TO PERFORM AS DESIGNED, AND PERSONS WHO RELY ON THE AIR MASK COULD SUSTAIN SERIOUS PERSONAL INJURY OR DEATH.
PAGE 2
ICM TX TABLE OF CONTENTS Contents ..................................................................................................................................................................................2 First Screen .............................................................................................................................................................................2 ICM Link .....................................................................................................
PAGE 3
ICM TX ICM LINK the ICM Tx Unit has been turned off (sleep mode). After 12 hours, the ICM Tx Unit will default back to the serial number. “Keep current ID in memory until next ID tag read” means that the ICM Tx Unit will retain the last read ID tag information until another ID tag has been read into the ICM Tx Unit. Writing ICM settings Note: The ICM Tx Unit data must be read before settings can be written to the unit.
PAGE 4
ICM TX ID TAG WRITER Writing information to the ID Tag 1. While in the ID tag writer portion of the program, first select the type of ID information to be entered by clicking either “Name” or “Jumpseat Position”. 2. Next, enter up to 30 characters of ID information in the entry box titled “Tag Data”. 3. Insert the ID tag into the port in the front of the ICM Tx Reader/ ID Tag Writer. The tag should be inserted unit it bottoms out. 4. Click “Write Tag”. Navigating the Data Memory Window 1.