OPERATOR'S MANUAL Cat. No. 0;) '&' MX FUEL™ HANDHELD CORE DRILL WARNING To reduce the risk of injury, user must read and understand operator's manual.
attached to a rotating part of the power tool may result in personal injury. •Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. •Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothing away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.
that can make a connection from one terminal •Operate power tool by insulated grasping surto another. Shorting the battery terminals together faces, when performing an operation where the cutting accessory may contact hidden wiring •Under abusive conditions, liquid may be ejected or its own cord. Cutting accessory contacting a from the battery; avoid contact. If contact ac- “live” wire may make exposed metal parts of the cidentally occurs, flush with water.
• dust created by power sanding, WARNING Some sawing, grinding, drilling, and other ADDITIONAL BATTERY SAFETY RULES To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack or charger in fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain industrial chemicals, and bleach or bleach-containing products, etc., can cause a short circuit. Do not charge non-rechargeable batteries.
Diamond Core Bits Always use a suitable dust extraction solution. To prevent visible dust, an adequate supply of water WARNING - mond core performance: •Amount of water •RPM of core drill motor •Bit runout •Amount of steel •Size of embedded steel •Age of concrete •Aggregate (size, type, hardness, abrasiveness) •Type of sand–manufactured vs.
Performance Indicator -REDThe performance indicator LESS provides pressure feedback. PRESSURE The LEDs will light up one by one as pressure is applied to -GREENIDEAL PRESSURE the bit. Increase or decrease (STANDS) pressure on the bit to reach the green "Ideal Pressure". -GREENN O T E : G r e e n " I d e a l GOOD PRESSURE Pressure" is best obtained -YELLOWusing a core drill stand. Most OK PRESSURE handheld applications will result in yellow "OK" or green -YELLOWMORE "Good" pressures.
When drilling with water, route the water away 13. To stop the machine, remove the bit from the hole and release the trigger. Make sure the bit comes to from the work area or use a liquid collection dea complete stop before laying down the machine. vice to keep work area dry and reduce the risk of 14. If the bit binds, release the trigger and wait for the bit to stop completely. Free the bit from the machine or battery pack. workpiece. Provide for protection of all personnel and mate- 15.
4. Check for loose nuts and bolts. Tighten if required. 5. Check for excessive bit runout. Replace if required. If vibration continues to occur, remove the core and loose material. If vibration continues to occur after attempting these measures, return the rig to the nearest MILWAUKEE® service facility. Bit Binding Bit binding is caused by one of two things: a dull (glazed) bit or a poorly stabilised stand.
4. Insert the new battery (3V CR2032), with the positive side facing up. 5. Close the battery door and tighten the screw(s) securely. reduce the risk of personal inWARNING To jury, electric shock and damage, never immerse your machine in liquid or allow a Cleaning Clean dust and debris from vents. Keep handles clean, dry and free of oil or grease. Use only mild soap and a damp cloth to clean, since certain cleaning agents and solvents are harmful to plastics and other insulated parts.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE® prides itself in producing a premium quality product that is Nothing But Heavy DutyTM. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.
