OPERATOR'S MANUAL Cat. No. M18 FNCS18GS M18 FUEL™ 18GA NARROW CROWN STAPLER WARNING To reduce the risk of injury, user must read and understand operator's manual.
GENERAL POWER TOOL SAFETY WARNINGS Read all safety warnings, instrucWARNING tions, illustrations and specifica- moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. •If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. •Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles.
•Follow all charging instructions and do not charge your capability; contact MILWAUKEE® Tool or a trained the battery pack or tool outside the temperature professional for additional information or training. Charging im- •Maintain labels and nameplates. These carry important information. If unreadable or missing, contact a MILWAUKEE® service facility for a replacement. dust created by power sanding, SERVICE WARNING Some sawing, grinding, drilling, and other • person using only identical replacement parts.
2. Press the magazine release button and slide the magazine open. Place the tip of the fasteners into the bottom slot of the magazine; then lay the fasteners ADDITIONAL BATTERY SAFETY RULES To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack or charger in fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain industrial chemicals, and bleach or bleach-containing products, etc.
Reload Indicator Power/Actuation Selection To indicate that the magazine is almost empty of fasteners (about 4-5 left), the workpiece contact will not compress, preventing operation under usual pressure. Install more fasteners to continue working. NEVER wedge or hold back the WARNING workpiece contact mechanism during operation of the tool. Never attempt to clear a jammed workpiece contact by grasping the discharge area of the tool. Doing so could result in serious injury.
zine (to override the Reload Indicator) and Retracting a Dropped Striker press the workpiece contact against a workIf the striker becomes "dropped" and does not retract piece. Pull the trigger. The tool must operate. after an operation: Release the trigger. The driver must move up. 1. Remove battery pack. 8. Select the Contact Actuation Operation. 2. Remove all fasteners. Holding the workpiece contact away from the 3. Reinsert battery pack. workpiece, open the magazine (to override the 4. Turn tool ON.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE® prides itself in producing a premium quality product that is Nothing But Heavy DutyTM. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.