OPERATOR'S MANUAL Cat. No. M18 FDEX, M18 FPDEX M18 FUELTM HAMMERVACTM 26 MM & 28 MM DEDICATED DUST EXTRACTORS WARNING To reduce the risk of injury, user must read and understand operator's manual.
•Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. •If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. •Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles.
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE •Maintain dust extractor. Check for misalignment or binding of moving parts, breakage of parts FOR HOUSEHOLD OR COMMERCIAL USE. ADDITIONAL BATTERY SAFETY RULES extractor's operation. If damaged, have the dust extractor repaired before use. Many accidents are caused by poorly maintained tools.
To install the dust box: 1. Slide the dust box into the body of the HAMMERVAC™. 2. The dust box latches should snap into place. NOTE: Do not operate the HAMMERVAC™ without SYMBOLOGY V Volts Direct Current Read Operator's Manual Keep filter clean. Efficiency of the HAMMERVAC™ is largely dependent on the filter. A dirty filter will reduce the air flow and overall efficiency of the system. Do not clean with water or compressed air. Remove from dust box and tap clean. CAUTION Wear safety glasses.
Switching sides for the Depth Gauge Setting the Drilling Depth 1. Turn OFF the tool. 1. Fit the HAMMERVAC™ to the tool and bit. 2. Remove the battery pack. 2. Press and hold the depth gauge button and slide 3. Remove the depth stop (see "Removing/Installing the depth gauge to the desired depth. The drilling the Depth Stop"). depth is the last visible measurement shown when 4.
OPERATION MAINTENANCE reduce the risk of injury, WARNING To always unplug the charger and To reduce the risk of fire and injury, do not use to pick up flammable or combustible materials. Empty dust box completely before use. To reduce the risk of injury, always wear proper eye protection marked to comply with AS/NZS 1337.1. When working in dusty situations, wear appropriate respiratory protection or use a suitable dust extraction solution.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold by authorised dealers in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE® prides itself in producing a premium quality product that is Nothing But Heavy DutyTM. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.