OPERATOR'S MANUAL Cat. No. M18 COS230 M18 FUEL™ 230MM (9'') CUT-OFF SAW W/ ONE-KEY WARNING To reduce the risk of injury, user must read and understand operator's manual.
GENERAL POWER TOOL SAFETY WARNINGS WARNING Read all safety warnings, instruc-- tions provided with this power tool. Failure to follow all instructions listed below may result in Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. WORK AREA SAFETY •Keep work area clean and well lit. Cluttered or dark areas invite accidents.
•When battery pack is not in use, keep it away • from other metal objects, like paper clips, coins, Wheels keys, nails, screws or other small metal objects, that can make a connection from one terminal mounting hardware of the power tool will run out of to another. Shorting the battery terminals together balance, vibrate excessively and may cause loss of control. •Under abusive conditions, liquid may be ejected •Do not use damaged wheels. Before each use, from the battery; avoid contact.
• tion your body and arm to allow you to resist kickback forces. Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction during start-up. The operator can control torque reactions or kickback forces, if proper precautions are taken. •Never place your hand near the rotating accessory. Accessory may kickback over your hand. •Do not position your body in line with the rotating wheel.
FUNCTIONAL DESCRIPTION ASSEMBLY only with the charger WARNING Rechargefor the battery. For spe- 10 8 9 manual supplied with your charger and battery. Removing/Inserting the Battery To remove the battery, press the battery door button and open the battery door. Push in the release buttons and pull the battery pack away from the tool. remove battery pack before WARNING Always changing or removing accessories. To insert the battery, press the battery door button and open the battery door.
To use the water, open the water supply valve by 4. To remove lock in place with the hex wrench and loosen the turning it in line with the water supply tube. Turn on the water supply and allow the water to run. spindle bolt with the scrench. NOTE: For best results, allow the water to coat the entire cutting wheel before operation. wheel. Making a Cut ONE-KEY™ 1. If performing a wet cut, connect the hose to the tool. 2. Insert the battery pack. 3. Start the tool.
If the tool does not start or operate at full power with a fully charged battery pack, clean the contacts on the battery pack. If the tool still does not work properly, return the tool, charger and battery pack, to a MILWAUKEE® service facility for repairs. ONE-KEY™ Burn Hazard. WARNING Chemical This device contains a lithium button/coin cell battery. A new or used battery can cause severe internal burns and lead to death in as little as 2 hours if swallowed or enters the body.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE®prides itself in producing a premium quality product that is Nothing But Heavy Duty®. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.