M18 FMCS Original instructions
I II III IV V VI VII Technical Data,Safety Instructions, Specified Conditions of Use, Declaration of Conformity, Batteries, Maintenance, Symbols Please read and save these instructions!
1. 2. 1. 2.
78-100 % I 55-77 % 33-54 % 10-32 % <10 % 3
1. II 1 2 2.
3. II 4.
5. 1 II 2 6.
STOP START 1 III 2 For safety reasons this power tool is fitted with a switch lock and the On-/Off switch cannot be locked in the „On“ position 7
III Insulated gripping surface 8
IV Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece.
1. 2. IV 3.
1. 2. START 1 V 2 3. 2. 4. STOP 5.
ON VI 12
VI 13
A VI B max.
VI 2 1 15
TECHNICAL DATA Metal saw Production code VII Battery voltage No-load speed Saw blade dia. x hole dia Saw blade thickness Blade teeth Max. cutting capacity Steel Metal pipe Ø Sections max. Weight according EPTA-Procedure 01/2014 (Li-Ion 2,0 Ah ... 9,0 Ah) Recommended Ambient Operating Temperature Recommended battery types Recommended charger Noise information Measured values determined according to EN 62841.
Kickback causes and related warnings – kickback is a sudden reaction to a pinched, jammed or misaligned saw blade, causing an uncontrolled saw to lift up and out of the workpiece toward the operator; – when the blade is pinched or jammed tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator; – if the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of the wood causing the
VII BATTERIES Battery packs which have not been used for some time should be recharged before use. Temperatures in excess of 50°C (122°F) reduce the performance of the battery pack. Avoid extended exposure to heat or sunshine (risk of overheating). The contacts of chargers and battery packs must be kept clean. For an optimum life-time, the battery packs have to be fully charged, after use. Battery packs which have not been used for some time should be recharged before use.
GB-DECLARATION OF CONFORMITY We declare as the manufacturer under our sole responsibility that the product described under „Technical Data“ fulfills all the relevant provisions of the following Regulations S.I. 2012/3032 (as amended), S.I. 2008/1597 (as amended), S.I.
Copyright 2020 Techtronic Industries GmbH Max-Eyth-Straße 10 71364 Winnenden Germany +49 (0) 7195-12-0 www.milwaukeetool.eu Techtronic Industries (UK) Ltd Fieldhouse Lane Marlow Bucks SL7 1HZ UK (11.