OPERATOR'S MANUAL Cat. No. M12 SI M12™ SOLDERING IRON WARNING 比例 1.000 To reduce the risk of injury, user must read and understand operator's manual.
GENERAL POWER TOOL SAFETY WARNINGS Read all safety warnings, instrucWARNING tions, illustrations and specifica- tools are dangerous in the hands of untrained users. •Maintain power tools and accessories. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. •Use the power tool, accessories and tool bits etc.
SYMBOLOGY •Work in well ventilated areas. Soldering can produce fumes and smoke. Volts •Use personal protective equipment when using Follow Direct Current all manufacturer instructions. •Maintain labels and nameplates. These carry CAUTION! Tip is hot. Avoid contact. important information. If unreadable or missing, contact a MILWAUKEE® service facility for a replacement. Regulatory Compliance Mark dust created by power sanding, • (RCM).
8. While still hot, clean the tip with a wet sponge or the battery pack. If the tool still does not work brass cleaning wire. WARNING! Avoid contact, tip properly, return the tool, charger and battery pack, to a MILWAUKEE® service facility for repairs. is hot and could cause serious burns. 9. Place tool on its side with the tip away from any reduce the risk of personal inWARNING To contact until it has coolded.
