OPERATOR'S MANUAL Cat. No. M12 CH SDS PLUS M12™ FUEL™ 16mm (5/8") SDS PLUS 2- MODE ROTARY HAMMER TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.
General POWER TOOL SAFETY WARNINGS WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. attached to a rotating part of the power tool may work area SAFETY result in personal injury.
•When battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire. •Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
ASSEMBLY OPERATION WARNING Recharge only with the charger specified for the battery. For specific charging instructions, read the operator’s manual supplied with your charger and battery. WARNING Always remove battery pack before changing or removing accessories. Only use accessories specifically recommended for this tool. Others may be hazardous. WARNING Always remove battery pack before changing or removing accessories. Only use accessories specifically recommended for this tool.
Starting, Stopping and Controlling Speed 1. To start the tool, grasp the handle firmly and pull the trigger. NOTE: An LED is turned on when the trigger is pulled. 2. To vary the speed, increase or decrease the pressure on the trigger. The further the trigger is pulled, the greater the speed. 3. To stop the tool, release the trigger. Make sure the tool comes to a complete stop before laying the tool down.
ACCESSORIES WARNING Always remove battery pack before changing or removing accessories. Only use accessories spec recommended for this tool. Others may be hazardous. For a complete listing of accessories refer to your Milwaukee Electric Tool catalog or go online to www.milwaukeetools.com.au / www.milwaukeetools.co.nz. To obtain a catalog, contact your local distributor or service center. Side Handle Assembly (optional) Cat. No.
Milwaukee Electric Tool Corporation 13135 West Lisbon Road, Brookfield, Wisconsin U.S.A. 53005 Milwaukee Electric Tool Corporation (Australia) Techtronic Industries (Australia) Pty. Ltd. Doncaster, Victoria, Australia, 3108 Milwaukee Electric Tool Corporation (New Zealand) Techtronic Industries (New Zealand) Pty. Ltd.