OPERATOR'S MANUAL Cat. No. L4 CLL, L4 CPL REDLITHIUM® USB CROSS LINE LASER, CROSS LINE & PLUMB POINTS LASER WARNING To reduce the risk of injury, user must read and understand operator's manual.
• DO NOT DISASSEMBLE. Incorrect reassembly may result in the risk of electric shock, fire or exposure to battery chemicals. If it is damaged, take it to a MILWAUKEE® service facility. • BATTERY CHEMICALS CAUSE SERIOUS BURNS. Never allow contact with skin, eyes, or mouth. If a damaged battery leaks battery chemicals, use rubber or neoprene gloves to dispose of it. If skin is exposed to battery fluids, wash with soap and water and rinse with vinegar.
FUNCTIONAL DESCRIPTION SYMBOLOGY Volts 1. Laser apertures 2. Laser mode indicator Direct Current 4. Pivot Bracket LASER RADIATION DO NOT STARE INTO BEAM 5. Battery compartment CLASS 2 LASER PRODUCT 6. Fuel gauge 7. Micro adjust 8. USB power outlet Universal Serial Bus (USB) 9. USB power inlet 10. Magnets Magnets 2 Read operator’s manual 1 1 Amps 3 1 Regulatory Compliance Mark (RCM). This product meets applicable regulatory requirements.
Disposing of MILWAUKEE® Li-Ion Battery SPECIFICATIONS Cross Line ................................................. L4 CLL Cross Line and Plumb Points.................. L4 CPL USB Input Volts ............................................ 5V DC USB Input Amps ..................................... 0.1 - 2.1 A Output Volts .................................................. 4V DC Output Amps ....................................................2.1 A REDLITHIUM® USB Batteries Volts ...............................
Mounting/Adjusting the Laser Level OFF Turns OFF the laser and locks the penThe pivot bracket can be used to mount the laser level in multiple ways: and store the Laser Level in the protective •Use the embedded magnets to secure the laser level carrying case. to framing steel studs, steel beams, etc.
ACCURACY FIELD CHECK the Accuracy Field Check NOTICE Perform procedure immediately upon 5. Move the tool within 30cm of wall B. Allow the laser to self level. Align the laser cross in the general direction of point II on wall B. unboxing of each new Laser Level and before exposure to jobsite conditions. See "Accuracy Field Check" for information. Should any deviation from listed product accuracy be found, please contact a MILWAUKEE® service facility.
. For the Measuring distance of 2 x 10m = 20m, the maximum allowable deviation (d) is: 20m x ±3.18mm ÷ 10m = ±6.36mm Thus, the difference d between points I and III should not exceed 6.5mm (max.) at 20m. Horizontal Leveling Accuracy A free measuring space of approximately 10m (33') x 10m (33') on a firm surface between two walls or structures A and B is required for the check. It is also suggested to mount the Laser Level to a commercially available Tripod for easy adjustment.
9. The maximum vertical deviation (d) is: MAINTENANCE d max = 2X H (door opening) x ±3.18mm ÷ 10m To reduce the risk of injury, always Example: for a door opening height of 2.05m, the WARNING remove the battery before performmaximum permitted deviation (d) is: d max = 2 x 2.05m x ±3.18mm ÷ 10m = ± 1.3mm ing any maintenance. Never disassemble the tool. Maintain Laser Level Therefore, the measurement between points III and IV on the upper door opening should not Maintain tools.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold by authorised dealers in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE® prides itself in producing a premium quality product that is Nothing But Heavy DutyTM. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.
