CS60 Original instructions
I II III IV V VI x cm x cm VII VIII TIP Technical Data,Safety Instructions, Specified Conditions of Use, Declaration of Conformity, Batteries, Maintenance, Symbols Please read and save these instructions! Aufnahme aufschrauben
1. I 1 2. 3.
1.4. 1 I EN 847-1 2 5.
2x I 4
1. Start 2.
II Insulated gripping surface 6
0 – 45° 0 – 56° III 56° 56° 0 – 45° 56° 3 2 56° 0 – 56° 2 1 49 mm 35 mm 61 mm 0° ................. 45°.......................
III 1 3 90° If a correction of the 90° angle of the guide-plate to the saw blade is necessary, use the correction screw.
x cm x cm 1. 1 IV 2 2. Carry out a test cut 3.
V 1 2 3 0 – 61 mm 10
V Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece.
Aufnahme aufschrauben VI AS 300 ELCP 12
Aufnahme aufschrauben TIP 1. Start VII 2. 3.
Aufnahme aufschrauben TIP 1. 1 VII 0° > 0° 2.
Aufnahme aufschrauben TIP 3. VII 4.
TIP Aufnahme aufschrauben 5. Stop VII 6.
TIP Aufnahme aufschrauben VII max.
Technical Data Circular saw Production code VIII CS 60 Rated input No-load speed Saw blade dia. x hole dia Max. Cutting depth at 90° / 45° / 56° Saw blade thickness Blade teeth Weight according EPTA-Procedure 01/2014 Noise information Measured values determined according to EN 62841.
– if the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back toward the operator. Kickback is the result of saw misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below. a) Maintain a firm grip with both hands on the saw and position your arms to resist kickback forces.
EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that the product described under “Technical Data” fulfills all the relevant provisions of the directives 2006/42/EC 2014/30/EU 2011/65/EU (RoHS) and the following harmonized standards have been used.
SYMBOLS CAUTION! WARNING! DANGER! Please read the instructions carefully before starting the machine. Always wear goggles when using the machine. Wear ear protectors! Wear a suitable dust protection mask. Wear gloves! Always disconnect the plug from the socket before carrying out any work on the machine. VIII Accessory - Not included in standard equipment, available as an accessory. Class II tool.
Copyright 2020 Techtronic Industries GmbH Max-Eyth-Straße 10 71364 Winnenden Germany +49 (0) 7195-12-0 www.milwaukeetool.eu Techtronic Industries (UK) Ltd Fieldhouse Lane Marlow Bucks SL7 1HZ UK (11.