Cut Sheet

ManualsBrandsMilwaukee ManualsBladesCUTTING WHL 12 X 1/8 X 1

Page 1 of 3 Revision Date: September 2004

METCo P/N: 58-97-0050

Legend: Drawing No.: 1A

Y - Yes

N - No

N/A – Not Applicable

Material Safety Data Sheet

May be used to comply with

OSHA’s Hazard Communication Standard 29 CFR 1910.1200.

This standard must be consulted for specific requirements

IDENTITY (As used on label and list) Note: Blank spaces are not permitted. If any item is not applicable, or no

information is available, the space must be marked to indicate that.

Grinding Wheels

49-94-1220, 49-94-1405, 49-94-1410, 49-94-1415, 49-94-4500,

49-94-4505, 49-94-5000, 49-94-5005, 49-94-6300, 49-94-6305

Section I

Manufacturer’s Name Emergency Telephone Number

Milwaukee Electric Tool Corporation 1-800-424-9300

Address (Number, Street) Contact Telephone Number for Technical Information

13135 West Lisbon Road 262-781-3600 or 1-800-729-3878 (1-800-SAWDUST)

(City, State, and Zip Code) Date Prepared

Brookfield, Wisconsin 53005 September 2004

Section II - Hazardous Ingredients/Identity Information

Hazardous Components [Specific Chemical Identity, Common name (s)]

Ingredient % by

Weight

OSHA

Reg.

Y/N

CAS #

OSHA

PEL

ACGIH

TLV

California Prop

65 Reg. Y/N

IARC/NTP

Y/N

Aluminum Oxide, Non-Fiberous 40-90% N 1344-28-1 15mg/m3 10mg/m3 N N

Calcium Oxide 1-5% N 1305-78-8 5mg/m3 2mg/m3 N N

Carbon Black 0.1-1% N 1333-86-4 3.5mg/m3 3.5mg/m3 N N

Cured Phenol Formaldehyde Resin 3-12% N 9003-35-4 0ppm 0ppm N N

Fiberglass 0.003-10% N 65997-17-3 1fbr/cc 0fbr/cc N N

Inorganic Fluorides ** 2-10% N NA 2.5mg/m3 2.5mg/m3 N N

Manganese Compounds (*) ** 1-5% N NA NA NA N N

@Crystalline Silica, Quartz 0.001-1% N 14808-60-7 .1mg/m3 .1mg/m3 Y N

Silicon Carbide 80-90% N 409-21-2 10mg/m3 10mg/m3 N N

Sodium Silicate 5-15% N 1344-09-8 15mg/m3 0mg/m3 N N

Sulfates & Sulfides ** 1-10% N NA 0mg/m3 0mg/m3 N N

Zinc Compound (*) ** 1-5% N NA NA NA N N

Zirconium Oxide 30-50% N 1314-23-4 5mg/m3 5mg/m3 N N

(*) This substance is regulated under Section 313 of the Emergency Planning and Community Right-to-Know Act of 1986 and the Canadian National

Pollution Reduction Initiative (NPRI). The OSHA exposure limit represented above is for respirable dust and assumed to be worst case exposure to

100% crystalline silica; 10mg/m3/(%silica+2).

** Substance is a compound and/or mixture.

@ Actual grinding tests with wheels known to contain Crystalline Silica did not produce any detectable amount of respirable free Crystalline silica. The

grinding wheel may be comprised of only some of the above.

DOT Hazard Classification: Non-hazardous

SARA Title III Section 313: This product does not contain regulated levels of any toxic chemical subject to the reporting requirements of section 313 of

Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 372.

HMIS

Rating Numbers

Health Flammability Reactivity Personal Protection

1 0 0 A

Hazard Ratings: 0 = Minimum hazard 1 = Slight hazard 2 = Moderate hazard 3 = Serious hazard 4 = Severe hazard

A = Goggles B = Goggles + Gloves C = Face Shield, Gloves + Apron X = Special, See sections VII & VIII of this sheet

Section III - Physical/Chemical Characteristics

Boiling Point Specific Gravity (H

O=1)

N/A N/A

Vapor Pressure (mm/Hg.) Melting Point

N/A N/A

Vapor Density (Air=1) Evaporation Rate

N/A N/A

Solubility in Water

Non-soluble

Appearance and Odor

Solid article. Odorless.

Summary of content (3 pages)

PAGE 1
Material Safety Data Sheet May be used to comply with OSHA’s Hazard Communication Standard 29 CFR 1910.1200. This standard must be consulted for specific requirements IDENTITY (As used on label and list) Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.
PAGE 2
Section IV - Fire and Explosion Hazard Data Flash Point (Method Used) Flammable Limits LEL UEL N/A N/A N/A N/A Extinguishing Media N/A Special Fire Fighting Procedures N/A Unusual Fire and Explosion Hazards None Section V - Reactivity Data Stability Unstable Stable Conditions to avoid: X N/A Incompatibility (Material to avoid): Avoid acids of all types with a pH < 4.0 Hazardous Decomposition or Byproducts In use, dust and decomposing odors may be generated.
PAGE 3
Section VIII - Control Measures Respiratory Protection (Specify Type) Respirators required when airborne contaminant levels exceed the TLV’s. Ventilation Local Exhaust Special Use adequate ventilation. N/A Mechanical Other N/A See OSHA 29 CFR 1910.94 (Ventilation) and 29 CFR 1910.1000 (Air Contaminants) Protective Gloves Eye Protection N/A Always wear safety glasses or some type of eye protection. Other Protective Clothing or Equipment: Use of this product may create elevated sound levels.